Page 1
Drapery Motors & Remotes P R O G R A M M I N G Quick Start For model ML-710B On page 4, follow steps 1 - 4 to program the motor and the remote. Motors must be programmed individually.
Page 2
Components Connect to track pulley ML-710B Connect to motor Motor with battery Motor Battery Programming button LED indicator Charging port at the bottom ML-710MS Built-in power cable for hardwire or plug Programming button in connection LED indicator RF Antenna Crestron/ Lutron ports...
Page 3
REMOTE FRONT REMOTE BACK OPEN STOP CLOSE PROGRAM or P2 BATTERY SLOT Works with left controls Battery: CR2430 3V (for 2 channels) PROGRAM or P2 Works with right controls (for 2 channels) The STOP & P2 buttons are used for programming. During programming, the time between commands must be less than 4 seconds or the motor will exit Program Mode.
Page 4
ML-710B Programming Step 1: Mount the Motor and Battery • Determine which side of the drapery rod the motor will be mounted on. • Remove the pulley cap. • Mount the motor first by sliding the top pin into the pulley and twisting it into place.