Infinion PSoC CAPSENSE 4000T Quick Start Manual

1
18
17
16
15
14
13 12 11 10
NC P1_0 P3_0
GND GND GND
P2_0 P2_0 P0_4
P2_1 P2_1 P0_3
NC P2_2 P0_2
NC P2_3 P0_1
GND GND P0_0
P2_4 P2_4 GND
P2_5 P2_5 P4_1
P4_0 P4_0 P2_4
2
3
4
5
6
7
8
9
NC
GND
P0_4
P0_3
P0_2
P0_1
P0_0
GND
P4_1
P2_4
QUICK START GUIDE
PSoC™ 4000T CAPSENSE™ Prototyping Kit
CY8CPROTO-040T
Easy, out-of-the-box experience with 5th-generation CAPSENSE™ technology
demonstrating best-in-class low-power touch performance on PSoC™ 4.
1 USB Type-C connector (J1)
2 KitProg3 status LED (LED4)
3 PSoC 5LP MCU with KitProg3
TM
firmware (U2)
4 KitProg3 mode switch (SW3)
5 External power input (J10)*
6 Target MCU current measurement header (J2)
7 USER LED2 and User button
selection header (J6)
8 Power LED (LED1)
9 CAPSENSE 5-segment slider (CSS1)
TM
10 USER LED's (LED2, LED3)
11 MiniProg4 SWD interface header
provision (J7)*
12 PSoC 4000T MCU (U1)
TM
13 Target I2C/UART interface
selection switch (SW2)
14 CSD CAPSENSE button (CSB1)
TM
15 CAPSENSE proximity sensor (CSP1)
TM
16 CSX CAPSENSE button (CSB2)
TM
17 USER button (SW4)
18 RESET switch (SW1)
Note : *footprint only, not populated on the board
For more information, please visit: www.infineon.com/CY8CPROTO-040T
Published by Infineon Technologies AG 81726
Munich, Germany
© 2023 Infineon Technologies AG.
All Rights Reserved.
Step 1: Power up the kit
1. Ensure that the jumper is
populated at J2 header.
2. Ensure that the jumper is
populated at J6 (between Pin1
and Pin2).
3. Ensure the SW2 position is at I2C.
4. Connect the board to your PC using
the USB Type-C cable at J1
connector and observe that the
Power and Status LEDs
(LED1, LED4) turn ON.
Step 2: Test the operation
1. Touch one of capacitive button
(either CSB1 or CSB2) and the LED2
will turn ON.
2. Swipe capacitive slider and the
LED3 brightness will change
relative to finger position on slider.
Document Number: 002-38473 Rev. *A
Date: 11 / 2023