Centaur CEN-FRY10 Operating Instructions

Deep Fryer
Introduction :
1. Read These Operating Instructions thoroughly before installing
or using this Equipment. Improper installation or use can result
in equipment or property damage, electric shock or personal
injury.
2. Centaur deep fryers are heavy duty and are designed for
commercial use.
3. Only trained personnel should operate this equipment.
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions
should always be followed, including the following:
1. Plug electrical cord into a certified electrical outlet with a
corresponding voltage rating as listed on the machine model
labels.
2. Always unplug the electric cord when appliance is not in use
and before cleaning, adjusting or maintaining this machine.
Do not operate with a damaged cord or plug or after the
machine malfunctions, has been dropped or damaged. Use
authorized service for examination, electrical or mechanical
adjustment or repair.
3. This machine will be HOT during use and for a short time
after it is turned off – BE CAREFUL. Do not let children near
appliance. To avoid burns, do not let bare skin touch hot
surfaces. Keep combustible materials away from appliance.
4. Never leave an operating fryer unattended. Remember, hot
oil is dangerous.
5. This appliance is not intended for use near or around water.
Never locate appliance where it may fall into a vessel of
water.
6. Do not insert or allow foreign objects to enter any ventilation
or exhaust opening as this may cause an electrical shock,
fire or damage to the appliance. Do not block air intakes or
exhaust in any manner. Do not use on soft surfaces where
openings may become blocked.
OPERATING INSTRUCTIONS
November 10, 2020
CEN-FRY10, CEN-FRY16, CEN-FRY32
Electrical Requirements :
Refer to the product tag (serial plate) on the back of the unit
for voltage and wattage requirements. Be sure to plug unit
into grounded outlet with sufficient power.
WARNING: DURING NORMAL OPERATION, THE
EXTERIOR OF THE UNIT IS HOT!
Preparation :
1. Remove all packing pieces and lift unit out of the box.
2. Remove any outside packaging.
3. Set unit on a flat surface.
4. Position the unit near a power outlet. Avoid the use of
extension cords. Do not run cord under carpeting or
cover with runners or the like. Arrange cord where it
will not be tripped over.
5. This appliance has hot and live electrical parts inside.
Do not use it in areas where gasoline, paint or
flammable liquids are used or stored.
Caution: To reduce the risk of fire, the appliance is to
be mounted on floors of noncombustible construction
with noncombustible flooring and surface finish and
with no combustible material against the underside
thereof, or on noncombustible slabs or arches having
no combustible material against the underside thereof.
Such construction shall in all cases extend not less
than 12 inches beyond the equipment on all sides.
6. Remove any white plastic coating that may be affixed
to stainless steel surfaces.
7. If unit fails to work properly when first operated call
Global Solutions customer service at 1-800-782-6761.
Model Series: