Download Print this page
Sealey LED3602CF.V2 Instructions
Sealey LED3602CF.V2 Instructions

Sealey LED3602CF.V2 Instructions

Rechargeable 360 7 smd + 3w led inspection lamp lithium-ion

Advertisement

Quick Links

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instruction
manual
1. safety
inspect the cable and connector for wear and damage to ensure items are safe before connecting to the power supply. if worn or

damaged do not use.
ensure the lamp is fully charged before initial use.

do not charge in damp conditions.

do not turn the lamp on when it is being charged.

do not shine directly into your, another person's or an animal's eyes.

do not allow children to use the lamp.

do not handle or move the lamp whilst it is being charged.

do not use the lamp if you suspect that the battery or the lamp casing is damaged.

do not leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently

recharge the battery at least once every six months of non-use.
do not attempt to open, disassemble, modify or service the battery pack.

do not crush, puncture, short external contacts or dispose of in fire or water.

do not expose to temperatures above 60°c (140°).

replace only with the battery pack designated for this product.

recycle or dispose of used battery as stipulated by local regulation.

if the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. if it gets in your eyes, rinse thoroughly with cool

water and seek immediate medical attention.
2. introduction
unique and innovative 360° swivel and tilt function enables the light source to be positioned in any direction. exclusive patented design owned
and registered to Sealey. 7 Super bright SMD LEDs with magnified lens providing up to 300 lumen output with 120° spread of light, illuminating
the whole work area. includes an additional high power 3W led in the end for use as a directional torch. features two swivel hooks and
three rubber covered magnets, two on the rear and one on the end, which allow hands free operation. High quality 2.2Ah Lithium-ion battery
for longer life, no memory effect and a much slower discharge than traditional ni-mH batteries. micro usB charging port. supplied with high
quality braided usB cable.
3. specification
model no: ..................................................... LED3602 Series
includes: LED3602.V2, LED3602B.V2, LED3602G.V2, LED3602R.V2, LED3602Y.V2, LED3602CAMO.V2, LED3602BA.V2,
lED3602CF.V2, LED3602WE.
Battery: .....................................................3.7V - 2.2Ah Li-ion
led quantity: ................................................ 7 smd + 1 led
lumen output side(high/low)/top: ................. (350/200)/120lm
operating time side(high/low)/top: ..........................(3.5/7)/8hr
charging time: .............................................................. 3.5hrs
iP rating:..........................................................................iP54
minimum length: ......................................................... 255mm
maximum length: ........................................................ 270mm
important Warranty information
The battery fitted to this lamp is considered to be a consumable item and its ability to accept a charge will reduce over time.
We will provide warranty against mechanical and electrical defect for a period of one year - this does not cover fair wear and tear.
If the battery is not properly charged before first use, or regularly conditioned, its capacity will diminish.
under these circumstances we will not replace the battery regardless of whether the battery less than one year old.
© Jack sealey limited
instructions for
rechargeable 360° 7 smd + 3W led
inspection lamp lithium-ion
: led3602 series
model no's
Original Language Version
lED3602 SERIES | Issue 2(I) 27/10/17

Advertisement

loading

Summary of Contents for Sealey LED3602CF.V2

  • Page 1 360° swivel and tilt function enables the light source to be positioned in any direction. exclusive patented design owned and registered to Sealey. 7 Super bright SMD LEDs with magnified lens providing up to 300 lumen output with 120° spread of light, illuminating the whole work area.
  • Page 2 Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey Ltd’s Batteries Producer Registration number (BPrn) is BPrn00705.

This manual is also suitable for:

Led3602.v2Led3602b.v2Led3602g.v2Led3602r.v2Led3602y.v2Led3602camo.v2 ... Show all