Advertisement
Quick Links
The action and intonation on the Taylor SolidBody are set to our precise standards using .010-.046 gauge electric
guitar strings. These instructions are for those who wish to alter the factory settings. All adjustments should be done
by a qualified repair technician.
The Taylor SolidBody:
Action and Intonation Adjustments On The Bridge
Advertisement
Related Manuals for Taylor 200 Series 210
Summary of Contents for Taylor 200 Series 210
- Page 1 The action and intonation on the Taylor SolidBody are set to our precise standards using .010-.046 gauge electric guitar strings. These instructions are for those who wish to alter the factory settings. All adjustments should be done by a qualified repair technician.
- Page 2 2. Bezel: The bezel sits in a shallow pocket in the top of the guitar and houses the stoptail assembly. 3. Bottom Plate: The bottom plate is accessible from the back of the guitar and sandwiches the guitar body between the plate and the bezel.
- Page 3 Adjusting the Bridge Height: Step-by Step Instructions Note: The strings do not need to be loosened to make bridge height adjustments. To access the action height adjustment screws, remove the four cover plate screws (Fig 1), then remove the plate. Raising the Action 1) Using a 3/8 (10 mm) socket or nut driver, carefully loosen the treble side anchor nut ½...
- Page 4 Note: You will need to remove the anchor nut from the treble side to access the high E string saddle locking screw. • 1980 Gillespie Way • El Cajon, CA 92020-1096 • (800) 943-6782 • (619) 258-3797 fax • www.taylorguitars.com Taylor Guitars FIGURE 4 - Intonation Set Screws FIGURE 5 - Nylon-Tipped Locking Screw For additional information, contact the Taylor Guitars...