Urban A300D Installation, Operation And Maintenance Instructions

CARE AND MAINTENANCE
1. Regular washing down of the exterior surface will help prolong the lustre of the painted finish.
2. Painted fountains that become dull due to prolonged exposure to direct sunlight can be
restored with an appropriate surface polish.
3. To maintain the exterior of the fountain carefully remove any loose surface deposits with a wet sponge.
Use a soft (non abrasive) brush and dilute a solution of mild detergent (eg. PH-neurtral liquid hand
washing detergent in warm water (DO NOT use solvents) to remove dust, salt and other deposits.
Rinse thoroughly with clean fresh water to remove residues. To remove any Tea Staining on
Stainless Steel surfaces we recommend Drifter Hull cleaner and stain remover.
4. Do not use any solvents on the surface as this will adversely affect the longevity of the painted
finish.
5. Surface scratches and inconsistencies can be touched up using Dulux touch up paint.
Most colours can be matched.
6. We recommend the use of anti-seize paste on all external fixing bolts to maintain ease of
access over long periods of time.
7. Check the fountain internal connections, water flow and all external access screws and fixing
bolts regularly (every 3mths) to ensure they are tight.
8. In high debris areas (parks, children's playgrounds etc) where there may be sand or bark or
a lot of leaf letter that may be placed in to the basin, check regularly and remove debris to
prevent blocking of the basin or the waste outlet pipe.
9. After any interruption to the water supply, always flush the lines prior to reconnection to the
fountain to prevent debris entering the valve.
WARRANTY
All Urban Fountains and Furniture outdoor drinking fountains are covered by a 2 year manufacturers
guarantee against faulty materials and workmanship under normal wear and tear conditions.
All fountains are date stamped at the time of despatch.
This warranty will only apply under the following conditions:
• The fountain was installed in accordance with our installation instructions that are supplied
with every fountain.
• The fountain was installed by a licensed plumber
• The water lines have been thoroughly flushed prior to connection to the fountain
• The fountain has not been tampered with or repaired in any way without obtaining prior
approval from our factory specialists first.
• The fountain has been serviced and maintained as per our supplied instructions.
ATTENTION PLUMBERS
This fountain uses "Push In Fittings".
Failure to release these fittings correctly
will result in leakage.
These quick release fittings allow instant
connection and disconnection
without the use of spanners.
Push outer ring in to
release tube from fitting
Drinking Fountains
Models: A300; A300D
INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
Model: A300
SPECIFICATIONS
1/2" bsb water inlet (15mm)
40mm waste outlet
O
Maximum Temperature: 40 c
Maximum Water Pressure: 2000 kpa
Complies with ATS 5200.105:2005 Technical
Specification for plumbing and drainage
products Part 105: Appliances - Beverage
dispensers and icemakers
Complies with AS/NZS 4020:2005 Testing of
products in contact with drinking water
CUSTOMER SERVICE
07 3382 7372
07 3287 5598
Model: A300D
2 year
warranty
office@urbanff.com.au
www.urbanff.com.au
Quality Certified
AU1228-QC