XIT 404 AQUATICA 5D Mounting Instructions

Revsion 2.0 - JUL2013
AQUATICA 5D/5D2/5D3 TRIPOD BRACKET
MOUNTING INSTRUCTIONS
3/16" HEX KEY
1/4-20 X 5/8" SCREWS 1/4-20 X 5/8" SCREWS
1/4" WASHERS 1/4" WASHERS 1/4" WASHERS
TRIPOD BRACKET
RED SPACERS RED SPACERS
PRESS INTO BRACKET PRESS INTO BRACKET
HOUSING HOUSING
Thank you for purchasing Xit 404's Tripod Bracket. Below are mounting instructions
On the back is our warranty and information to help you prolong the life of your
tripod bracket.
Tripod Bracket Mounting Instructions
1. Assemble all the parts you will need on a flat surface: your housing,the hardware
mounting kit (supplied), Tripod Bracket, corrosion inhibitor such as Lanapro or
Lanocote (not included), and drawings.
2. Identify the correct mounting holes to use on the tripod bracket.
3. Press the Red Spacers into the tripod light bracket per the drawing.
4. Place your housing upside down on a table.
5. Orient the Tripod Bracket so there is one Ball Adaptor on each side, and one
towards the back of the housing.
6. Align the correct mounting holes on the tripod bracket with the holes on
your housing.
7. Thread the screw(s) provided, using corrosion inhibitor on the screw threads,
through the tripod light bracket into your housing. Tighten screws with hex key
provided.
IMPORTANT: You need to use corrosion inhibitor (such as Lanapro or Lanocote) on
the screw threads. Be sure to disassemble the tripod bracket from the housing after
each diving trip and clean it of any salt buildup or corrosion.
PRODUCT CODE: TS2001AQ
www.xit404.com