Table of Contents
Advertisement
Quick Links
INSTALLATION CERTIFICATE
The undersigned qualified installer attests to have personally fitted the here described vehicle
security system following the manufacturer instructions.
By :
Sold on :
................................................
Vehicle :
..........................................................................................................................
GEMINI Technologies S.r.l.
Via Luigi Galvani 12 - 21020 Bodio Lomnago (VA) - Italy
Tel. +39 0332 943211
www.gemini-alarm.com
ISO 9001 Certified Company
863 - 863/24
T
ype of product
:
862
861
863 - 863/24
862
861
INSTALLATION AND
USE MANUAL
Made in Italy
UK
AC2710/UK Rev.05 - 03/22
Advertisement
Table of Contents
Related Manuals for Gemini 863
Summary of Contents for Gemini 863
- Page 1 INSTALLATION CERTIFICATE The undersigned qualified installer attests to have personally fitted the here described vehicle security system following the manufacturer instructions. By : 863 - 863/24 863 - 863/24 Sold on : ype of product ..........INSTALLATION AND Vehicle : ..........................
-
Page 2: Table Of Contents
Before installing, identify your alarm USER MANUAL model and refer to it for the correct instructions. 862: same as 863 without self-powered battery. - OPERATING DESCRIPTION..................PAGE 03 861: same as 862 without override key, engine block, comfort feature and positive output with system 2.1 - System total arming.................... -
Page 3: User Manual
2.1 - SYSTEM TOTAL ARMING 2.6 - SYSTEM ARMED Press remote control button 1 or touch the override key to its receptacle. After the arming delay the system is fully armed and ready to detect any alarm event. The LED will start System arming is confirmed by 2 Beeps and 2 flashes of the turn indicators. -
Page 4: Pin Code Customization
This setting is used if the self-rearming or passive arming functions have been enabled. NB: Only for 863 and 862 alarm systems with override key. Valet mode prevents the system from automatically arming. It is useful when the alarm must be... -
Page 5: Installer Manual
INSTALLER MANUAL 8.0 - WIRING DIAGRAM 6.0 - CONNECTOR PINOUT Before carrying out electrical connections, WIRE FUNCTION WIRE COLOUR disconnect the negative - 1 - Bonnet switch negative input GREEN battery terminal and re- - 1 - External sensors negative input GREEN-BLACK connect only after completion. -
Page 6: Programmable Functions
9.0 - PROGRAMMABLE FUNCTIONS 10.0 - SYSTEM PROGRAMMING 9.1 - ACOUSTIC SIGNALS Make sure not to modify the functions that have been programmed at the time of This function activates the acoustic signals that confirm system arming/disarming. installation. 9.2 - PANIC ALARM OR CAR-FINDER The system has been factory configured, to modify the settings proceed as follows: Programmable feature (Default setting: panic alarm). -
Page 7: 11.0 - Programming New Devices
11.0 - PROGRAMMING NEW DEVICES 12.0 - DELETING PROGRAMMED DEVICES To carry out the operation successfully, make sure the required electrical connections To carry out the operation successfully, make sure the required electrical connections (door switch, bonnet switch and ignition) are properly connected. (door switch, bonnet switch and ignition) are properly connected. -
Page 8: Ultrasonic Volumetric Protection
ULTRASONIC VOLUMETRIC PROTECTION 15.0 - TECHNICAL SPECIFICATIONS 13.1 - CONNECTIONS AND POSITIONING Power supply 863 - 862 - 861 12 Vdc nsert the WHITE connector in the “W” marked socket and the RED connector in the “R” marked Power supply 863/24 24 Vdc socket (see figure below).