Page 1
INSTALLATION CERTIFICATE The undersigned qualified installer attests to have personally fitted the here described vehicle security system following the manufacturer instructions. By : 863 - 863/24 863 - 863/24 Sold on : ype of product ..........INSTALLATION AND Vehicle : ..........................
Before installing, identify your alarm USER MANUAL model and refer to it for the correct instructions. 862: same as 863 without self-powered battery. - OPERATING DESCRIPTION..................PAGE 03 861: same as 862 without override key, engine block, comfort feature and positive output with system 2.1 - System total arming....................
2.1 - SYSTEM TOTAL ARMING 2.6 - SYSTEM ARMED Press remote control button 1 or touch the override key to its receptacle. After the arming delay the system is fully armed and ready to detect any alarm event. The LED will start System arming is confirmed by 2 Beeps and 2 flashes of the turn indicators.
This setting is used if the self-rearming or passive arming functions have been enabled. NB: Only for 863 and 862 alarm systems with override key. Valet mode prevents the system from automatically arming. It is useful when the alarm must be...
9.0 - PROGRAMMABLE FUNCTIONS 10.0 - SYSTEM PROGRAMMING 9.1 - ACOUSTIC SIGNALS Make sure not to modify the functions that have been programmed at the time of This function activates the acoustic signals that confirm system arming/disarming. installation. 9.2 - PANIC ALARM OR CAR-FINDER The system has been factory configured, to modify the settings proceed as follows: Programmable feature (Default setting: panic alarm).
11.0 - PROGRAMMING NEW DEVICES 12.0 - DELETING PROGRAMMED DEVICES To carry out the operation successfully, make sure the required electrical connections To carry out the operation successfully, make sure the required electrical connections (door switch, bonnet switch and ignition) are properly connected. (door switch, bonnet switch and ignition) are properly connected.
ULTRASONIC VOLUMETRIC PROTECTION 15.0 - TECHNICAL SPECIFICATIONS 13.1 - CONNECTIONS AND POSITIONING Power supply 863 - 862 - 861 12 Vdc nsert the WHITE connector in the “W” marked socket and the RED connector in the “R” marked Power supply 863/24 24 Vdc socket (see figure below).