Page 2
INTRODUCTION IMPORTANT: Read through this This instruction demonstrates procedures instruction manual thoroughly and for installing an A&I Products canopy on familiarize yourself with the tractor open operator station tractors. before installing the canopy. Recognize Safety Information This is a safety-alert symbol. When you see this symbol on your machine or in this manual, be alert to the potential for personal injury.
Page 3
HARDWARE KIT COMPONENTS Use this chart to identify individual component quantities used. REF. # PARTS LIST DESCRIPTION QUANTITY Canopy A-C299BK Canopy Bracket Kit A-C35830 Side Mount Plate A-C29940 Hardware Kit 3/8” Lock Nut 3/8” x 1” Bolt 1/2” Washer 1/2” Lock Nut U-Bolt 2.5”...
INSTALLATION PROCEDURES Section View A Section View B Your A&I tractor canopy will fit Roll Over Protection Systems (ROPS) that are 31.56” and 32.28” in overall width with frames that are 2’ - 2.36” in size. It is also designed to fit ROPS that are angled up to 33° forward or backwards.
Page 5
The side mount plates are reversible to accommodate forward and rear angled ROPS. The side mount plates are slotted, this will allow adjustment to level the canopy once installed. The orientation of the side mount plates are shown below (the curved edge will match the angle of the ROPS). Fig.