Advertisement
Quick Links
Advertisement
Summary of Contents for 360 Hunting Blinds 360 Series
- Page 1 ASSEMBLY MANUAL...
-
Page 2: Safety Disclaimer
SAFETY DISCLAIMER At no time shall 360 Hunting Blinds be liable for any accidents due to normal or improper use of blinds or tower stands. We recommend that you follow standard safety procedures when entering and exiting the blind, or climbing or decending the ladder. - Page 3 STEP 1 INSTALL THE LEGS Install 8” – 12” 4x4s into the pockets on the fl oor and secure with 3 – 3” deck screws per foot. If you purchased a tower stand you may skip this step. STEP 2 INSTALL THE CARPET Align the carpet roll to the edges of the blind fl...
- Page 4 STEP 3 INSTALL THE FIRST PANEL Set the fi rst panel into place. Have one person hold the top of the panel while another person aligns the bottom. Make sure the corners of the panel match with the corner of the fl oor and that the panel doesn’t gap away from the fl...
- Page 5 STEP 5 INSTALL WALL PANELS Start at the top of the panel, align the tops and outsides of the panels to make sure they are even. Work the panels to align the outside edges and fasten the panels together with a screw at the top.
- Page 6 STEP 7 LIFT THE ROOF Lift the roof to the top of the blind and rest it on top ofthe walls. Balance it on the back walls of the blind far enough to make room for installing the remaining wall panel and door panel.
- Page 7 STEP 9 INSTALL THE DOOR PANEL With the roof and wall panels in place it’s time to install the door. Caulk both wall panels, then set the door panel in place and fasten like the other wall panels. If you fastened any wall panels to the fl...
- Page 8 STEP 11 FASTEN THE WALLS If there are wrinkles in the carpet, use a fl at bar or prybar to lift the wall pan- els and push wrinkles back out. Then fasten the wall panels to the fl oor with several screws.