WAREMA Omnexo 2M230 AP Installation Instructions

Omnexo switch actuator
2/4/6M230 AP
Installation instructions
General information
Fig. 1 Omnexo switch actuator 2/4/6M230 AP
The Omnexo switch actuator 2/4/6 M230 AP is a device
for the central operation of up to six 230 V AC sun shading
drives (the following uses the sun shading actuator for six
motors as an example).
It is operated via the Omnexo control system. The drives
and switch actuator are supplied with 230 V AC.
The Omnexo switch actuator 2/4/6M230 AP functionality
can be set. The control behaviour can be adjusted to the
different requirements of the various products.
Controlling the light and load is not permitted and
will result in a device fault.
Intended use
The Omnexo switch actuator 2/4/6M230 AP is an
electronic device for controlling sun shading devices. The
approval of the manufacturer must be obtained for any use
of the device other than its intended purpose specified in
these instructions.
Safety instructions
W ARNING
The electrical installation (assembly)/
dismantling must be performed by a
certified electrician in accordance with
VDE 0100 and/or with the standards
and legal requirements pertaining to
the respective country. The electrician
must observe the installation notes and
instructions included with the electrical
devices supplied.
warema_2052439_alhb_en_v2•2023-04-01
W ARNING
If hazard-free operation cannot be
assumed, the device must not be started
or must be deactivated. This assumption is
justified if:
 the housing or the connecting lines show
signs of damage
 the device is no longer working.
W ARNING
It is important to comply with the following
points in the interest of personal safety.
Children must not play with the operating elements
of the control unit or the remote control. Store remote
controls out of reach of children.
Make sure that no persons or objects are in the path of
the driven parts (internal and external venetian blinds,
etc.).
Disconnect the device from the operating voltage
if cleaning or other maintenance work must be
performed!
C AUTION
When using window drives, the installer
of the system must ensure that the
safety regulations and precautions
of DIN EN 60335-2-103 "Particular
requirements for drives for gates, doors and
windows" as well as ASR 1.6 "Windows, roof
lights, transparent walls" are observed.
W ARNING
The switch actuators may only be used
to control such window drives where the
movement of the window cannot cause any
injuries.
Function of the sun shading actuator
You will find a detailed description of the functions for
Omnexo sun shading actuators in the Omnexo software.
The software is available to download at
www.warema.com/en/omnexo/.
We reserve the right to make technical modifications
Valid from
1 April 2023
Keep for future use.
1