Whitehall WH2142-W-3 Installation, Operation & Maintenance Manual

INSTALLATION, OPERATIONS & MAINTENANCE MANUAL
WH2142-W-3 / WH2142ADA-W-3
Wall Supply, Floor Waste Toilet
WH2142-W-EGE10 (SHOWN)
TECHNICAL ASSISTANCE TOLL FREE TELEPHONE NUMBER:
Technical Assistance E-mail: Fieldservice@acorneng.com
Important: Some options may slightly alter installation. To ensure proper installation review the manual
thoroughly and verify rough-ins before beginning any work. File this manual with the owner or maintenance
personnel upon completion of installation.
MGI Engineered Plumbing Products are designed in accord with applicable National Codes and Standards,
which may include UPC, ANSI, and ASSE. Installers should use industry standard practice for details not
covered within Manual. Prior to installation, supply lines must be flushed of all foreign material such as pipe
dope, chips, or solder. Debris or foreign material in water supply may damage valve. An appropriate thread
sealant is recommended on all threaded waste and supply connections to reduce the possibility of leaks.
Toilet requires a minimum of 25 PSI flow pressure and uses a minimum water consuption of 1.28 GPF.
WH2142 Toilet fixtures are supported on-floor and are not intended for use with In-Wall Support Carriers.
Depending on wall construction, rear wall may require backing for mounting fixture to wall. Installer provided
wall anchors and wall anchoring hardware must be appropriate for wall construction.
ANSI, UFAS or ADA compliance is subject to the interpretation and requirements of the local code authority
and is the responsibility of the installer for verification.
TOILET WASTE CONNECTIONS
Units with Wall Waste Outlets are provided using a 5-1/2" Diameter Recessed Gasket Flange and Floor
Waste units will receive a 7-1/2" Diameter Recessed Gasket Flange. The Stainless Steel Gasket Flange is
welded in place to the Toilet P-trap, and is fabricated to be flush with the back of the unit (wall outlet) or flush
with the bottom of the fixture (floor outlet). The depth of the Recessed Gasket Flange is 1/2" deep.
The Recessed Gasket Flange is intended for installation and assembly with a common 3" or 4" Toilet Closet
Flange Fitting, Yoke Adapter or similar. The Recessed Gasket Flange provided includes (2) 5/16" UNC
Threaded Captive Nuts, which are on 6" centers. These tapings allow for assembly of Closet Bolts and may
assist to provide for the Squeeze of the Gasket to seal the waste connection. Certain installation conditions
may not require using the tapings. Choice of the Gasket material is up to the installer however, it is common
for Neoprene or Felt Gaskets to be used with Wall Waste Toilet units.
Please refer to the Link or QR code provided.
For Cleaning & Care Guide:
https://www.whitehallmfg.com/uploads/fileLibrary/9900-008-W01.pdf
WHITEHALL MANUFACTURING • P.O. BOX 3527 • City of Industry, CA 91744-0527 U.S.A.
Phone (800) 782-7706 • (626) 968-6681 • Fax (626) 855-4862 • Web: www.whitehallmfg.com
Drawing # 6900-233-001 05/01/2023
WH2142-T-3 / WH2142ADA-T-3
Top Supply, Floor Waste Toilet
WH2142-T-EGE10 (SHOWN)
1.800.591.9360
®
1
®
Best-Care Toilet