Low pressure and The 117 series pressure switch utilizes a bellows or diaphragm sensor to differential pressure units, models 520-535, 540-548, are also available with detect a pressure change.
Page 3
GAPPING Part II - Adjustments 1) Loosen adjustment lock. Tools Needed 2) Turn 5/8” hex adjustment screw in, to approximately mid range. This 5/8” Open End Wrench puts a load on the sensor and exposes the plunger flats. Using a 1/4” wrench on the plunger and a 3/16”...
Page 5
Operation of the unit up to maximum pressure or temperature is accept- able on a limited basis (e.g., start-up, testing) but continuous operation must be restricted to the designated adjustable range. Excessive cycling at maximum pres- sure or temperature limits could reduce sensor life.