inaa SPM150L Installation Manual

Tankless compact pressurized solar water heater
INSTALLATION MANUAL
The using enviroment should be ≥ 0℃ .
2. Technical data & packing list
2.1 Technical data
42kgs
80℃
Optional(1.5KW/2KW)
2.2 Packing List
Dear customers:
1. Congratulation on your purchase of our solar water heater products. For your convenience
and safe use, please read the instructions carefully before use and follow the instructions. The
models mentioned in this manual are subject to continuous improvement without prior notice.
If there is a physical object that does not conform to the instructions, the actual product shall
prevail.
2. We insist on honesty and trustworthiness as the foundation, treat people with sincerity. We
provide a wide range of national after-sales service network, we provide you with perfect service,
the real solution to your troubles.
Notes:
1. The installation may only be carried out by the qualified professionals.
2.The pipes must be insulated with a suitable UV resistant material of the appropriate thickness
in order to reduce heat loss and protect the pipes from freezing.
3. If you choose the model with heating element and controller function, you must have reliable
grounding. It is strictly forbidden to use this product without reliable grounding.
4.To avoid scalding, when the temperature of hot water is higher than 50℃, it must be mixed
with cold water before use.
5. It should be installed in a sunny and open area for getting high efficiency.
6. Unfiltered water can cause system corrosion, it is recommended to use soft water.
7. The system may only be installed on a roof surface. The static load-bearing capacity of the roof
must be checked in accordance with local and regional stipulations at the site prior to the
installation of the panels, if necessary by means of the commissioning of a structural engineer.
Please observe the installation instructions, the company will not be responsible
for damage and safety accidents caused by improper operation of the user!
3. Accessories list
1. Packing List
M8*35
42kgs*2
80℃
2.
Optional accessories( flat roof)
Optional(1.5KW/2KW)
3. Optional accessories
( electric heater for back up)
Heating element 1.5/2 KW (G3/4")
M6*40 Combined valve
Fixing sheet
M8*45
Front track
Fixing press pad Support leg
Temperature
Controller PM18
Sensor
1. Specification characteristics:
A. The structure is simple and easy to install. The heat collecting parts and the water tank are
combined into one. The circulation of hot and cold water and the flow heating process are
carried out internally.
B. The product is easy to promote and use. It is very suitable for ordinary people's domestic
hot water demand.
6
1
3
2
5
4
1. Tempered safety solar glass 5. Drain hole
2. Clear heat insulation 6. Outlet hole
3. Storage tank 7. Reser ved hole
4. Case 8. Inlet hole
Simple
installation
The accessories for
installation are inside
of this cover.
1. Open package 2. Mount
7
8
3. Plug&Use