Pullman Holt SC400 Operation & Care Instructions

Self-Contained Extractor
Models SC400 & SC600
This extractor is a high quality, precision made product. All parts used in the manufac-
turing of this extractor have passed rigid quality control standards prior to assembly, and
an "each unit" final inspection prior to packaging is your assurance of proper assembly.
This extractor was protectively packed to prevent possible damage in transit. Should
damage occur, please notify the transporting carrier immediately for loss and/or claim.
GROUNDING:
This machine must be grounded while in use to protect the operator
from electric shock. The extractor is equipped with an approved
three-conductor cord and three-prong grounding type plug to fit the
proper grounding type receptacle. The green (or green and yellow)
conductor in the cord is the grounding wire. Never connect the green
(or green and yellow) wire to a live terminal.
If your unit is for use on less than 150
volts, it has a plug like that shown in
Figure A.
If it is for use on 150 to 250 volts, it has a
plug like that shown in Figure D.
An adapter (Figures B&C) is available for connecting Figure A plugs
to two-prong receptacles. The green-colored rigid ear, lug etc., must
be connected to a permanent ground such as a properly grounded
outlet box. No adapter is available for a plug as shown in Figure D.
Adapter shown in Figure B & C is not for use in Canada.
CAUTION
Service and repair should be performed only by a qualified tech-
nician. Call (800) 237-7582 for the location of the nearest
Pullman-Holt Authorized Service Center.
Operation & Care Instructions
Save For Future Reference
IMPORTANT SAFEGUARDS
WARNING
To avoid the possibility of electrical shock, the extractor must be
grounded during use. Plug the electrical power cord into a
grounded wall receptacle (120 volts, 60 Hz only). Do not oper-
ate the machine on an ungrounded building circuit or if the
ground lug has been removed from the power cord plug. If the
building receptacle does not have ground connection, use an
adapter as shown in figure B.
EXTENSION CORDS:
Machines that have 3 wire cords requiring grounding must only be
used with extension cords that have 3-prong grounding type plugs
and 3-pole receptacles. Use only three wire #14 or larger gauge
extension cord. The maximum recommended extension length is 40
feet.
Before using an extension cord, inspect it for loose or exposed wires,
damaged insulation and defective connections.
CAUTION
Always disconnect power cable from outlet
when working on this machine.