Advertisement
Quick Links
INSTALLATION INFORMATION
EMG MODELS: 35P4, 35P4A (4-STRING)
35P5 (NARROW 5-STRING)
35J, 35JA (4-STRING OR NARROW 5-STRING)
SPECIFICATIONS:
Logo Color
Magnet Type *
Resonant Frequency (KHz)
Output Voltage (Finger, Thumb)
Output Voltage (Thump)
Output Noise (60 Hz)
Output Impedance (Kohm)
Current @9V (Microamps)
Battery Life (Hours)
Maximum Supply (Volts DC)
*Note: Magnet Type: A (Alnico) C (Ceramic) C/S (Ceramic and Steel)
PICKUP AND MAGNET DIMENSIONS:
All EMG-35 Models have the same housing dimensions (shown above).
The drawings below show the magnet placement for all versions. You should check the width of your strings against the magnet dimensions below
to make sure there is sufficient string coverage. A rule of thumb for any pickup is that the total magnet width should be the string width plus twice
the distance the pickup is from the strings. So, If the pickup is 3/16" (5mm) from the strings, with a magnet width of 2.90" (73.5mm) the maximum
string width would be 2.50" (64mm). If your strings are too wide for the pickups shown below, choose one of the EMG-40 Extended Series Pickups,
with a 4 inch (101mm) housing, where similar styles of EMG pickups are available.
Warranty
All EMG Pickups and accessories are warranted for a period of two years. This warranty does not cover failure due to improper installation, abuse or damage. If
upon examination the pickup is determined to be defective, a replacement will be made. Warranty replacement products are covered by this same warranty. This
warranty covers only those pickups and accessories sold by authorized EMG Dealers. This warranty is not transferable.
© 2014 Copyright EMG INC. All Rights Reserved.
35P4
35P4A
Silver
Gold
C
A
3.20
2.61
2.00
2.00
4.50
4.50
-106
-101
10
10
80
80
3000
3000
27
27
MAXIMUM RECOMMENDED STRING WIDTH 2.50" (63.5) ALL 35 MODELS
EMG-35P4 / 35P4A
1.200
1.200
(30.5)
(30.5)
EMG-35J / JA
2.900
(73.6)
.125 (3.17) DIA. MOUNTING HOLES
.750
(19.0)
MODEL:
35J
35JA
Silver
Gold
C
A
3.95
3.20
2.00
1.50
4.50
4.50
-101
-99
10
10
80
80
3000
3000
27
27
EMG-35P5
1.650
(41.9)
EMG-35CS/DC
3.500
(88.9)
3.250
(82.5)
35P5
35CS
Silver
Silver
C
C/S
3.20
3.95
2.00
2.00
4.50
6.00
-106
-109
10
10
80
235
3000
3000
27
27
1.200
(30.5)
2.900
(73.6)
R .125
TYP
1.500
(38.1)
.880
(22.3)
35DC
Silver
C
4.85
2.00
6.00
-107
10
235
3000
27
Advertisement
Related Manuals for EMG 35J
Summary of Contents for EMG 35J
- Page 1 Warranty All EMG Pickups and accessories are warranted for a period of two years. This warranty does not cover failure due to improper installation, abuse or damage. If upon examination the pickup is determined to be defective, a replacement will be made. Warranty replacement products are covered by this same warranty. This warranty covers only those pickups and accessories sold by authorized EMG Dealers.
- Page 2 2) Power Supply tips are on page 4. If your instrument has a battery holder, of the pickup as shown above. you are installing this pickup with an older EMG, or you want to supply your Note the orientation arrow.
- Page 3 OUTPUT CABLE If your instrument has a selection switch: BRIDGE PICKUP INPUT Shown at the right is the EMG B245 Pickup Buss which is used for NECK PICKUP INPUT instruments that have 2 pickups and a 3 position selection switch.
- Page 4 BRIDGE PICKUP the diagram above, but use a Balance control instead of 2 Volume controls. Again, the EMG Active Tone Control shown in this diagram can be replaced with the EMG-EXB Expander, or the EMG-BTC. 9V+ POWER BUSS - 9V +...