Icon Electronics D3-VMD0-T Operating Instructions

ReTransmit devices (-T)
The 4 -20mA re-transmitted signal is optically isolated from the input signal. By default the re-transmittion parameters are set so that the
output follows the full scale input.
Description:
This device is used to display and monitor DC voltage. Maximum & Minimum values are logged for 24 hours (updated every 60 min).
The relay(s) may be used for over and / or under protection. The latch facility may be de-activated for one or both the relays
allowing one relay to be used for control (not latched), and the other as a latched alarm. Use the "ScAL" parameter for calibration
purposes, or to change the number of decimal places displayed (see notes). Other features include adjust able signal damping,
adjustable start-up and reaction delays, the ability to swap the relay's functionality. All settings may be locked & code protected
to avoid changes from being made by unauthorised personnel.
0 RELAY
This device is used to display DC voltage.
1 RELAY
The voltage applied is displayed according to the scale specified. The relay remains energised while the input signal is between
the upper and lower set points. Once de-energised, the signal must change in the opposite direction by the hysteresis amount
before the relay will re-energise. The relay's action may be swapped to energise when the setpoint is reached. Note: the relay
will NOT re-energise while the latch pins are shorted. The latch pins can also be used as a reset.
2 RELAY
The voltage applied is displayed according to the scale specified. The relays remain energised while the input signal is between
the upper and lower set points. Once de-energised, the signal must change in the opposite direction by the hysteresis amount
before the relay will re-energise. Either relay's action may be swapped to energise when the setpoint is reached. Note: the
relay will NOT re-energise while the latch pins are shorted. The latch pins can also be used as a reset.
Adjustable parameters:
Please note: Depending on the model of the device purchased, some of the parameters listed below may not be available
· Upper limit for relay 1 "Hi 1" (default: disabled)
When the input rises above this value, the relay changes state until the signal drops by the hysteresis amount
(see "HYS.1" setting)
· Lower limit for relay 1 "Lo 1" (default: disabled)
When the input drops below this value, the relay changes state until the signal rises by the hysteresis amount
(see "HYS.1" setting)
D3
53mm
DIN rail mount
DC VOLTAGE MONITOR
incl 4-20mA or 0-10V re-transmit
EXAMPLE: D3-MD 0-T = 0 RELAY
Operating instructions and Guarantee Certificate
www.iconelectronics.co.za
P44
48mmx48mm
panel mount
D3-VMD 0/1/2-T
P44-VMD 0/1/2-T
P49-VMD 0/1/2-T
P49
48mmx96mm
panel mount