Zennio Lumento C4 Technical Documentation

4-channel constant current PWM dimmer for DC LED loads
ZDI-RGBCC4
FEATURES
•
Control of constant current RGBW LED loads or 4 independent channels
•
Output currents: 220 mA, 300 mA, 350 mA, 500 mA, 550 mA, 630 mA,
700 mA, 750 mA, 900 mA and 1000 mA
•
External 12-30 VDC power supply
•
LED test function
•
Integrated KNX BCU (TP1-256)
•
Dimensions 165 x 44 x 23 mm
•
Surface-mounted inside panels or boxes
•
Conformity with the CE, UKCA, RCM directives (marks on the back side)
1. KNX 2. Programming
connector button
5. Test LED 6. Current
selector switch
Programming button: short press to set programming mode. If this button is held while plugging the device into the KNX bus, it enters the safe mode.
Programming LED: programming mode indicator (red). When the device enters the safe mode, it blinks (red) every half second. During the start-up
(reset or after KNX bus failure) and if the device is not in safe mode, it emits a red flash.
Test button: if this button is held for more than 3 seconds, the device enters the test mode.
Test LED: it indicates which channel (red=channel 1/R, green=channel 2/G, blue=channel 3/B) is being tested during test mode. In addition, it shows
errors in the installation and/or parameterization (see section "test LED error identification").
GENERAL SPECIFICATIONS
CONCEPT
Type of device
Voltage (typical)
Voltage range
KNX supply Maximum
consumption
Connection type
External power supply
Operation temperature
Storage temperature
Operation humidity
Storage humidity
Complementary characteristics
Protection class
Operation type
Device action type
Electrical stress period
Degree of protection
Installation
Minimum clearances
Response on KNX bus failure
Response on KNX bus restart
Operation indicator
Weight
PCB CTI index
Housing material
¹ Maximum consumption in the worst-case scenario (KNX Fan-In model).
© Zennio Avance y Tecnología S.L.
3. Test button
7. Programming
LED power supply
Voltage
29 VDC (typical)
24 VDC¹
Edition 8
1
4. Output
channels
8. External
DESCRIPTION
Electric operation control device
29 VDC SELV
21-31 VDC
mA
8
10
Typical TP1 bus connector for 0.8 mm Ø rigid cable
12-30 VDC
0 .. +55 °C
-20 .. +55 °C
5 .. 95%
5 .. 95%
Class B
III
Continuous operation
Type 1
Long
IP20, clean environment
Independent device to be surface-mounted inside electrical panels or boxes.
The installation is also possible in false ceiling. Connect the device as near
as possible to both, the load to dimmer and the external power supply.
Not required
Data saving according to parameterization
Data recovery according to parameterization
The programming LED indicates programming mode (red). The Test LED
indicates the following events: red light on with test mode (red), green light
on with test mode (green), blue light on with test mode (blue), white light on
with test mode (white), power supply reverse polarity (orange), power supply
error (blinking orange), inconsistency between parametizered current and
switch position (blinking white), overheating error on level 1 (blinking red)
and level 2 (red).
96 g
175 V
PC FR V0 halogen free
Further information
Lumento C4
TECHNICAL DOCUMENTATION
3
2
7
8
Figure 1: Lumento C4
mW
232
240
www.zennio.com
4
5
6
Page 1/2