Zennio inBOX DIM Technical Documentation

Universal Dimmer for Flush Mounting - 1 Output (250W@230VAC / 200W@110V) / 2 A/D inputs
ZDI-IBD
FEATURES
▪ 1 channel for R L C loads and for dimmable CFL and LED lamps.
▪ Automatic detection of R L C load type.
▪ Automatic frequency detection.
▪ Dimming pattern selection for CFL and LED lamps.
▪ Optional manual dimming control.
▪ 2 inputs configurable as
▪
Binary input.
▪
Temperature probe.
▪
Motion sensor.
▪ 10 logical functions.
▪ External 110/230VAC 50/60Hz power supply.
▪ Total data saving on KNX bus failure.
▪ Integrated KNX BCU.
▪ Dimensions Ø50 x 26mm.
▪ Can be mounted within distribution boxes, junction boxes or wall
back boxes.
▪
Conformity with the CE directives (CE-mark on the back side).
1. Output status LEDs
5. External power supply
Programming/test button: short press to set programming mode. If this button is held while plugging the device into the KNX bus, it enters the safe
mode. If this button is held for more than 3 seconds, the device enters the test mode.
Programming/Test LED: programming mode indicator (red). When the device enters into safe mode, it blinks (red) every half second. The manual
mode is indicated by the green color. During the start-up (reset or after KNX bus failure) and if the device is not in safe mode, it emits a red flash.
GENERAL SPECIFICATIONS
CONCEPT
Type of device
Voltage (typical)
Voltage range
KNX
Maximum
supply
consumption
Connection type
External power supply
Operation temperature
Storage temperature
Operation humidity
Storage humidity
Complementary characteristics
Protection class
Operation type
Device action type
Electrical stress period
Degree of protection
Installation
Minimum clearances
Response on KNX bus failure
Response on KNX bus restart
Operation indicator
Weight
PCB CTI index
Housing material
(1)
Maximum consumption in the worst case scenario (KNX Fan-In model)
© Zennio Avance y Tecnología S.L.
2. Programming/Test button
6. Output
DESCRIPTION
Electric operation control device
29VDC SELV
21...31VDC
Voltage
29VDC (typical)
(1)
24VDC
Typical bus connector TP1 for rigid cable 0.80mm Ø
110/230VAC 50/60Hz
0ºC to +40ºC
-20ºC to +55ºC
5 to 95% RH (no condensation)
5 to 95% RH (no condensation)
Class B
II
Continuous operation
Type 1
Long
IP20, clean environment
Independent device to be mounted inside distribution boxes, junction boxes or wall
back boxes.
Not required
Data saving according to parameterization
Data recovery according to parameterization
The programming LED indicates programming mode (red) and test mode (green).
Each output LED indicates its status (fixed = active output; flashing = dimming error)
43g
175V
PC FR V0 halogen free
Edition 1
1
2
3. Programming/Test LED
7. Output control buttons
mA
8.2
10
Further information www.zennio.com
inBOX DIM
Technical Documentation
6
5
7
3
4
Figure 1. inBOX DIM
4. Inputs
8. KNX connector
mW
237.8
240
Page 1 / 4
8