Download Print this page

Amtrol THERM-X-TROL ST-400C Series Installation, Operation & Service Instructions

Thermal expansion absorbers

Advertisement

Quick Links

READ
INSTALLATION,
MAINTENANCE MANUAL.
INSTRUCTIONS AND WARNINGS IN THE MANUAL MAY
RESULT IN SERIOUS OR FATAL INJURY AND/OR PROPERTY
DAMAGE, AND WILL VOID THE PRODUCT WARRANTY.
THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED
PROFESSIONAL. FOLLOW ALL APPLICABLE LOCAL AND
STATE CODES AND REGULATIONS, IN THE ABSENCE OF
SUCH CODES, FOLLOW THE CURRENT EDITIONS OF THE
NATIONAL PLUMBING CODE AND NATIONAL ELECTRIC
CODE, AS APPLICABLE.
This product must be installed by a qualified
professional.
EXPLOSION HAZARD. Failure to follow the
instructions in the accompanying product
manual can cause a rupture or explosion; possibly causing
serious or fatal injury, leaking or flooding and/or property
damage.
Use only with potable water system. Do not
operate in a setting with freezing temperatures
or where the temperature can exceed 240°F and do not exceed
the maximum working pressure specified for this Product in the
Manual. Mount vertically only.
This Product, like most Products under
pressure, may over time corrode. weaken
and burst or explode, causing serious or fatal injury, leaking or
flooding and/or property damage. To minimize risk, a licensed
professional must install and periodically inspect and service the
Product. A drip pan connected to an adequate drain must be
installed if leaking or flooding could cause property damage. Do
not locate in an area where leakage of the tank or connections
could cause property damage to the area adjacent to the
appliance or to lower floors of the structure.
Chlorine & Aggressive Water: The water
quality can significantly influence the life of
this Product. You should test for corrosive elements, acidity, total
solids and other relevant contaminants, including chlorine and
treat your water appropriately to insure satisfactory performance
and prevent premature failure
THIS IS THE SAFETY ALERT SYMBOL.
ALERT YOU TO POTENTIAL PERSONAL INJURY AND
OTHER HAZARDS. OBEY ALL SAFETY MESSAGES THAT
* All ST-C Series models come with a 1 year warranty. See
reverse side for warranty information.
Part #: 9017-092 (04/11)
INSTALLATION, OPERATION & SERVICE INSTRUCTIONS
THERMAL EXPANSION ABSORBERS (ST-400C & 450C SERIES)
1400 Division Road, West Warwick, RI 02893
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY
CAREFULLY
THE
PRODUCT
OPERATING
FAILURE TO FOLLOW THE
IT IS USED TO
T: 401.884.6300
FOLLOW THIS SYMBOL TO REDUCE THE RISK
OF PERSONAL INJURY AS WELL AS PROPERTY
AND
DAMAGE.
pressure in excess of local code requirement or maximum
working pressure designated in the Product Manual, whichever is
less.
Do not expose Product to freezing temperatures or
temperatures in excess of 240° F. Do not adjust the pre-charge
or re-pressure this Product except for any adjustments required
at the time of initial installation, especially if Product corroded,
damaged or with diminished integrity. Adjustments to pre-charge
must be done at ambient temperature only. Failure to properly
size the Product or follow these instructions may result in
excessive strain on the system and lead to Product failure,
serious or fatal personal injury, leakage and/or property damage.
Note: Inspect for shipping damage and notify freight carrier or
store where purchased immediately if damage is present. To
avoid risk of personal injury and property damage, if the product
appears to be malfunctioning or shows signs of corrosion, call a
qualified professional immediately. Current copies of the Product
manual can be viewed at www.amtrol.com. Use proper safety
equipment when installing.
CAUSING PRODUCT TO FAIL.
ALERTS APPEAR IN THE FOLLOWING INSTRUCTIONS.
the State of California to cause cancer and to cause birth defects
or other reproductive harm. (California Installer/Contractor -
California law requires that this notice be given to consumer/end
user of this product.) For more information: www.amtrol.com/
prop65/htm.
THERM-X-TROL
F: 401.885.2567
EXPLOSION OR RUPTURE HAZARD A
relief valve must be installed to prevent
FAILURE TO PROPERLY SEAL WILL
RESULT
IN
LOSS
OF
GENERAL SAFETY INFORMATION -
ADDITIONAL
SPECIFIC
CALIFORNIA PROPOSITION 65 WARNING:
This product contains a chemical known by
MARK OF THE ORIGINATOR
®
www.amtrol.com
PRECHARGE
SAFETY

Advertisement

loading

Summary of Contents for Amtrol THERM-X-TROL ST-400C Series

  • Page 1 Current copies of the Product Use only with potable water system. Do not manual can be viewed at www.amtrol.com. Use proper safety operate in a setting with freezing temperatures equipment when installing.
  • Page 2 Pre-Installation 4. To relieve initial thermal expansion, slightly open a hot water faucet. Continue until water heater aquastat 1. Visually inspect THERM-X-TROL for any damage. If ® temperature is satisfied. Once heater is at its operating damage exists, return product for replacement. range, no further bleeding of expanded water is required.
  • Page 3 What is covered by this Warranty AMTROL warrants to the purchaser or first user of the new Product that at the time of manufacture, the Product is free from defects in material and workmanship. Any warranty claim must be made within one (1) year unless another time period is set forth in the Manual, measured from the time the Product was purchased.
  • Page 4 1400 Division Road, West Warwick, RI 02893 T: 401.884.6300 F: 401.885.2567 www.amtrol.com...

This manual is also suitable for:

Therm-x-trol st-450c series