WAREMA LONMSE 2M230I Operating And Installation Instructions

LONMSE 2M230I / 4M230I
Operating and installation instructions
General information
Fig. 1: LONMSE 2M230I / 4M230I
The LONMSE 2M230I and 4M230I are LON
central and local operation of up to four mutually indepen-
dent sunshade drives. Central operation is provided by
connecting a LON FTT-10 twisted pair network; for local
®
operation, operating elements can be connected to the
device. To precisely determine and control the position of
the shade, there is one incremental encoder input for each
motor output. The drives and the motor control units are
supplied via a 230 V AC control line. The device also has
two or four signal inputs.
Intended use
The LONMSE 2M230I and 4M230I were developed to
control sun shading systems. The approval of the manu-
facturer must be obtained for uses outside of the purpos-
es listed in these instructions.
Safety instructions
WARNING
The electrical installation (assembly)/
dismantlingn must be performed by a
certified electrician in accordance with
the electrical installation regulations
published by the Association of German
Electrical Engineers (VDE 0100) or the
standards and regulations of the country
in which the equipment is installed. The
electrician must observe the installation
instructions included with the electrical
device.
WARNING
If hazard-free operation cannot be as-
sumed, the device may not be started or
must be deactivated. This assumption is
justified if
warema_890275_alhb_en_v7•2022-05-01
Children may not play with the operating elements of
the control unit or the remote control! Store the remote
controls out of reach of children.
Make sure that no persons or objects are in the range
of movement of the driven parts (blinds, external vene-
tian blinds, etc.).
Disconnect the device from the supply voltage if clean-
ing or other maintenance work must be performed.
actuators for
®
Information on the electrical installation
An on-site overload current protection device (fuse) and a
disconnecting and isolating switch to switch off the entire
system must be provided.
Installation
The motor control unit is, depending on the selected me-
thod of installation, designed for surface mounting (AP) or
for installation in a distributor (REG).
Surface-mounted housing
Insert a slotted screwdriver (recommendation: 3.0 -
4.0 mm blade) into the respective cover opening (see
Fig. 5) and carefully pry the folding cover open. Repeat
the procedure for the second opening of the cover.
The cover can be raised when both catches have
been released. The second cover can be opened in
the same manner. Alternatively, the surface-mounted
variant can be mounted on a DIN rail (TH 35-15). The
device type is not suitable for use in damp locations.
DIN rail-mounted housing
When installing the device in a distributor, clip it onto
a symmetrical DIN rail (TH 35-15). To ease connec-
tion of the device, the terminal covers can be removed
(see Fig. 2). One of the terminal covers can be re-
moved to connect the network.
Fig. 2: Loosening the terminal covers (DIN rail variant)
 T he housing or supply lines show signs of
damage,
 The device is no longer working.
WARNING
It is important to comply with the follow-
ing instructions in the interest of personal
safety.
Remove the terminal covers:
Insert a suitable screwdriver
into the notch!
We reserve the right to make technical modifications
Valid as of
1 May 2022
Keep for future use.
1