Download Print this page

OEM Premium Series SC-802 E Install Manual

Round ceiling speakers

Advertisement

Quick Links

See back for New Construction Rough-In details
1. Check ceiling area for concealed obstructions such as wiring, plumbing, heating ducts, etc.
2. Use a "stud finder" to locate positions of joists or rafters. Make sure that your intended locations for your
speakers is unobstructed and that the hole will be at least 2 inches away from joists or rafters.
3. Use the supplied compass or cut-out template/paint mask to draw a circle with the diameter that corresponds
to the model of your speaker on the chart below, and carefully cut out the hole.
4. Remove grille from speaker assembly using included grille remover.
5. Before installation, turn the "Angle Lug Installation Clamps" (Item A) so they are positioned as in photo below.
This way, they will clear the cut out hole for installation.
Models
AP-601
AP-611
AP-801
AP-811
6. Prior to inserting speaker assembly into cut-out hole, attach speaker wires. Make sure to observe polarity
(the "+" and the "-"). Speakers wired out of phase will exhibit an apparent loss of bass response. The wires
will be held in place by the "Spring Clip Terminals" (Item B). Wires should be stripped about .25
wire ends will assure a trouble free installation, but is not necessary.
7. Insert speaker assembly into hole and begin to tighten installation screws. As you start to turn each screw,
the "Angle Lug Clamps" will rotate outward to engage ceiling material (Item C). CAUTION: Do not over-
tighten the clamps. Too much torque may snap off the lug, causing the speaker not to seat securely. A snug
fit is all that is necessary to assure proper performance.
8. If speaker assemblies are to be painted, either before or after installation, use the paint masking template
(cardboard disc) to cover the speaker driver(s) to prevent damage. DO NOT TRY TO PAINT THE GRILLE
AND FRAME ASSEMBLY TOGETHER. The grille should always be painted separately. Use thin coats tak-
ing care not to block perforations with excessive paint.
9. If your speaker includes an "eyeball" type tweeter it may be aimed to achieve better imaging. Tweeter output
should be directed toward the typical listening position. USE CARE TO AVOID DAMAGING THE DOME OF
THE TWEETER DURING AIMING!!
Installation of Round Ceiling Speakers
Mounting
Diameter
7 3/8"
8 5/8"
OEM Systems Company, Inc.
www.oemsystems.com
A
B
C
Rear View of Speaker Assembly
"
. Tinning of

Advertisement

loading

This manual is also suitable for:

Sc-502eAp-601Ap-611Ap-801Ap-811