Advertisement
Quick Links
www.sukcesgroup.pl
In order to fully explore available functions of BESH series please take a moment and read this manual before using the device.
BESH transmitters are compatible with all YOODA brand devices.
1. General Information
Radio receiver range is a variable value and can differ from declared values depending on conditions in which device
operates. Possible sources of changes in range are building construction, interference caused by other radio transmitters
etc.
2. Detailed description
LCD display
UP button
STOP button
CHANNEL - button
DOWN button
Single-channel or 5-channel or 15-channel transmitter
BESH_1RT | BESH_5RT | BESH_15RT
CHANNEL + button
with timer (front)
1. Control:
can control single motor, or a group
of up to 20 motors on each channel
2. Range:
200 meters outdoor,
35 meters indoor
3. Battery:
1 x CR2430
4. Power supply:
3 V
5. Dimensions:
120 x 40 x 10 mm
6. Transmitting power:
10 mW
7. Operating temperature:
from 0°C to 50°C
8. Protection degree:
IP 30
Fifteen-channel BESH remote control
with display and timer, white (BESH_15RT)
P2
programming button
battery
Single-channel or 5-channel or 15-channel transmitter
1
TIME CHANGE
button
WORK MODE
button
with timer (back)
Advertisement
Related Manuals for YOODA BESH 1RT
Summary of Contents for YOODA BESH 1RT
- Page 1 BESH_1RT | BESH_5RT | BESH_15RT www.sukcesgroup.pl In order to fully explore available functions of BESH series please take a moment and read this manual before using the device. BESH transmitters are compatible with all YOODA brand devices. 1. General Information 1. Control:...
- Page 2 1.Difference between automatic time of roller shutter opening and closing cannot be shorter than 32 minutes. In case of smaller than minimal time difference fault message will appear and none of the changes will be saved. 2. Pressing UP or DOWN button in automatic or random mode will show currently set opening/closing time and symbol of current process.
- Page 3 6. Setting automatic time of closing and opening 1. Time can be set only when device is in automatic or random working mode. 2. Longer than 10 seconds pause between series of button clicks during programming will cause device to switch off from programming mode without saving any changes.