Table of Contents Before you use the Utility Software................3 DL-100T485 Utility Illustration ..................4 Connecting to the DL-100T485 ..................5 Retrieving Records......................6 Configuration .........................7 DL-100T485 Quick Start V.104...
2 for more information, or refer tonsection 3 for more information about the installation of this Utility. To download .NET Framework, refer to : http://www.microsoft.com/downloads/en/details.aspx?FamilyID=9cfb2d51 -5ff4-4491-b0e5-b386f32c0992&displaylang=en The Utility software is located on the attached CD at Napdos\DL_100\Utility. DL-100T485 Quick Start V.104...
PC and the DL-100T485. Clicking *“Functions->Get Records” or the icon retrieves the log data which is stored in the DL-100T485. Clicking *“Functions->Configuration” or the icon configures the DL-100T485. Clicking “Exit” or the icon closes the Utility software.
DL-100. If you are connecting to a new module, the default address will be 01 and the checksum will be disabled. Click the “OK” button to connect to the DL-100T485. Note: The LCD will also indicate the module address and the checksum status.
Retrieving Records After a connection between the PC and the DL-100T485 is established, you can retrieve the log data via the Utility software. The procedure is as follows: 1. Click the “Get” button and wait until the data is successfully received.
Configuration After the connection between the PC and the DL-100T485 has been established, click the “ ” icon to configure the DL-100T485. The details are shown as follows: 1. A new menu window would be created and the current module configurations will be displayed.
This manual is also suitable for:
Dl-100t485pDl-100t485-wDl-100t485p-wDl-100t485 crDl-100t485p crDl-100t485-w cr...
Show all