Niles RSL-6 Datasheet

P R E L I M I N A R Y
RSL-6
RSL-6
Remote Controlled Speaker Selection System

SPECIFICATIONS

IR Range
30 feet @ 30 degrees
off-axis
Audio Power
Handling
250 watts/channel con-
tinuous music power
Frequency Response
20 Hz to 20kHz +0dB,
-0dB (flat)
Mounting
Table-top component
Wiring Requirements
Individual runs of
2-conductor speaker
wire. Connectors can
accommodate 14-22
gauge
Overall Dimensions
17" Wide x 2" High x
8-3/4" Deep
Weight 6-1/2
LBS
FEATURES AND BENEFITS
FEATURES AND BENEFITS
Remote Control
The slim, elegant remote con-
trol (included) allows you to
completely control which
speakers are playing. Each pair
of speakers has its own /
ON
button. In addition, a program-
mable button (you
ALL ON
select which rooms will turn
on) and an button
ALL OFF
allow you to conveniently stop
or start your music with one
touch!
INTRODUCTION
INTRODUCTION
The RSL-6 is a Infrared Remote
Controlled Speaker Selection
System for up to six pairs of
speakers. The supplied remote
control enables you to select
any pair, any combination
of pairs, or all six pairs of
speakers at once. You don't have
to worry about overloading your
amplifier. The RSL-6 has a programmable
microprocessor that constantly monitors
which speakers are playing and selects exact-
ly the right amount of protection for your
amplifier.
Red LED turns green
POWER
momentarily confirming that an
IR command was detected.
RSL- 6 REMOTE HIGH DEFINITION SPEAKER SELECTION SYSTEM
Infrared Sensor Attractive low-
profile design.
Computerized Protection
The brain of the RSL-6 is an eight
bit modified Harvard Architec-
ture Microcontroller. The micro-
controller is programmed to
remember the impedance of
OFF
each of your speaker pairs and
your amplifier's ideal load. It
constantly monitors how many
speaker pairs are playing (and
which pairs), calculates the
exact amount of impedance
protection necessary, and pro-
vides the proper amount of pro-
tection for your amplifier.
T E C H N I C A L D A T A
Individual
tons for each pair
- button enables you to
ALL ON
turn on all or some of your speakers
depending upon the rear panel DIP
switch settings.
Red LED indicators Recessed areas for
for each pair of custom room labels.
speakers.
1 2 3
Simple push-button
ON
operation for each pair.
Room LED's and Labels.
Red LED's indicate when a pair
of speakers is on. 72 pre-print-
ed room labels are included for
easy identification.
®
X-10 Powerline Control
Using optional X-10 wireless
remotes and controllers you
can control the RSL-6 through
the existing 120v AC electrical
wires in your home. Optional
Niles TW-523 interface module
is required.
S H E E T
/ but-
ON OFF
of speakers.
button
ALL OFF
turns your entire
system off.
- button enables you to turn on
ALL ON
all or some of your speakers depending
upon the rear panel DIP switch settings.
4 5 6
/
OFF ALL OFF
entire system off.
Proudly Made in USA
The RSL-6 is made in Miami,
Florida and comes with a limit-
ed two year parts and labor
warranty.
B
L E N D I N G
A
A N D R C H I T E C T U R E
CONTINUED OTHER SIDE
Hand-held IR
remote gives you
convenient control.
ALL ON ALL OFF
button turns your
H F
I G H I D E L I T Y
®