Inel GM35LE-10 Original Instructions

GM35LE-10/09
Drive with integrated battery, recharged by energy from a solar
panel.
The drive is designed for wireless control of guards.
In order for the motor to work correctly with the roller shutter, it
is necessary to use hanger-locks on the winding tube and
stoppers in the bottom bar. The stoppers should be placed as
close to the guides as possible to improve comfort. A sill must
be fitted to the window and the length of the guard must match
the length of the guides.
1
Safety instructions
Basic guidelines
The drive is handed over in a condition for safe installation and use,
provided that all instructions in the operating manual are complied
with.
Conversion or changes to the drive are not permitted. Warranty
repairs may only be carried out by the manufacturer. Only original
spare parts and accessories should be used for post-warranty repairs.
Safe operation of the supplied drive is only guaranteed when used in
accordance with the manufacturer's specifications. The limits given in
the technical data must not be exceeded under any circumstances.
Supplementary safety provisions
Important safety and accident prevention regulations must be
observed when installing, commissioning and maintaining the drive.
The following provisions require special attention:
1. Fire regulations.
2. Accident prevention regulations.
General comments on hazards and safety
measures
The comments listed are general guidelines when using INEL
equipment in combination with other equipment. These indications
must be strictly adhered to when installing and operating the
equipment.
• Before installing the drive and setting the end positions, check the
tightening of all screw connections.
• The applicable safety and accident prevention regulations must be
observed.
• Wires and cables should be checked regularly for insulation damage
and conductor continuity.
• If the cables are found to be damaged, the damaged cables must be
replaced after the power supply has been switched off immediately.
Warning
• Do not let children play with the control devices.
• Keep remote control devices out of the reach of children.
• Watch the roller shutter moving and keep bystanders clear until it is
fully open or closed.
• Users of the roller shutter must be trained and instructed on how to
operate the roller shutter and on the dangers involved in its use.
People can be considered trained if the employer, administrator or
Przedsiębiorstwo Informatyczno-Elektroniczne INEL Sp. z o.o., ul. Mostowa 1, 80-778 Gdańsk, inel@inel.gda.pl
DC drive with integrated battery and radio receiver
powered by solar energy, type LE, model GM35LE-10/09
Original instructions PL
owner has allowed them to operate the roller shutter and instructed
them on how to use it.
2 Assembly instructions
2.1 Safety rules
 Installation of the drive must only be carried out by suitably
qualified persons.
 The weight of the roller shutter must not exceed the load capacity
of the drive as indicated in the selection table (table available at
www.inel.gda.pl).
 The proper way of laying the cable (loop facing downwards)
further protects the drive from possible water damage.
 Do not drill holes in the motor housing.
 Protect the motor from contact with any fluid.
 Avoid crushing, impact to the motor and protect the motor from
falling.

2.2 Assembly of the drive
 Attach the mounting bracket (A) to the side of the roller shutter
box, connect the adapter (D) to the motor drive ring.
Place the dog (E) supplied with the motor on the motor shaft and

secure it with the pin (F), then slide the entire drive into the
winding tube (G).
 Connect the winding tube and the drive dog with screws
or rivets (H)
NO YES
Figure 1
Figure 2.
www.inel.gda.pl