Safe Fleet SRB1AC101010 Connection Manual

Smart-Reach AC Base
Antenna Connection Guide
 WARNING: Professional Installation Required
Before installing or using the Smart-Reach AC Base
and antennas, consult with a certified, professional
installer trained in RF installation and knowledgeable in
local regulations including building and wiring codes,
safety, channel, power, outdoor/indoor restrictions, and
license requirements.
It is the responsibility of the end user to ensure that
installation and use complies with local safety and
radio regulations.
Ensure you review and adhere to all cabling and
installation requirements included in this Guide.
Package Contents (typical)
The contents of a typical installation package are shown
below (actual contents of your installation package may
vary):
• Smart-Reach AC Base (032-1025), including:
• Mounting accessories
• Ethernet connector accessories
• Ground cable connection accessories
• Access Point Installation Guide
• Antenna(s) and cable(s) as ordered
• Antenna Connection Guide (this document)
Model Number and Antenna ID
Use the following table and images to identify the connector
on the Smart-Reach AC Base to connect each antenna
cable.
For example, consider model # SRB1AC101010:
Model # SRB 1 AC
Description
Antenna ID
1 0 1 0 1
Antenna IDs
0 Custom/no antenna
1 2.4 GHz 5dBi Omni
2 5.8 GHz 7dBi Omni
3 2.4 GHz 6dBi Omni
4 5 GHz Grid (Back Haul)
6 2.4 GHz Mini Panel
9 Dual band 2.4/5GHz Mini Panel Antenna
Continuing with the example SRB1AC101010:
• 1 (following "SRB") indicates a single radio
• 1 (in 3 places under "Antenna ID") means 3 x 2.4GHz
5dBi Omni antennas, attached to connectors
#1, #3, and #5
0
© Safe Fleet | 2022 | All rights reserved | Part #: 700-1083 R2