Advertisement
Quick Links
OWNER'S MANUAL
Installation, Operating, Inspection and Maintenance Instructions
Applicable Models:
AD-1
AD-1C
AD-2
You must read and fully understand all instructions, or have all instructions
explained to you, before attempting to use this device. Equipment must not be
installed, operated or inspected by anyone who does not understand these
instructions. Failure to observe these instructions could result in serious injury
or death. Careless or improper use of this equipment can result in serious injury
or death. Training and instruction review should be repeated at regular intervals.
If you have any questions regarding these instructions or need additional
copies, call Gemtor, Inc. toll free at 800-405-9048
THESE INSTRUCTIONS SHOULD BE KEPT WITH THE DEVICE AT ALL TIMES.
Gemtor Anchor D-Rings
This user instruction manual is not a substitute
for a Comprehensive training program
GEMTOR, INC.
One Johnson Avenue
Matawan, NJ 07747
800-405-9048 • 732-583-6200
732-290-9391 (fax)
sales.info@gemtor.com
www.gemtor.com
Warning
IMPORTANT
Advertisement
Summary of Contents for Gemtor AD-1
- Page 1 Training and instruction review should be repeated at regular intervals. If you have any questions regarding these instructions or need additional copies, call Gemtor, Inc. toll free at 800-405-9048 This user instruction manual is not a substitute for a Comprehensive training program IMPORTANT THESE INSTRUCTIONS SHOULD BE KEPT WITH THE DEVICE AT ALL TIMES.
- Page 2 • One worker only! Never attach more than one worker to beam anchor. • Free fall distance shall not exceed 6 ft. • Do not try to adjust, repair or modify any Gemtor product. For prompt service, please contact: Gemtor, Inc., One Johnson Ave., Matawan, NJ 07747, 800-405-9048.
- Page 3 RAINING The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards. [OSHA 1926.503(a)(1)] The employer shall assure that each employee has been trained, as necessary, by a competent person qualified in the following areas:...
- Page 4 NSTALLATION ON EAM OR THER TRUCTURAL TEEL Locate and identify an approved compatible anchorage/structure. Be sure that the mounting location is clean and free of debris. Locate or drill a ½” diameter hole. Consideration should be given to allow sufficient clearance to place the lock washer and tighten the nut.