Marvel Avengers Tornado Maker Quick Start Manual

A. SAFETY MESSAGES
1. Adult supervision and assistance are required at all times. Please read through all the instructions and keep them since they contain
important information.
2. This kit is intended for children 8 years or older.
3. This kit and its finished product contain small parts which may cause choking if misused. Keep away from children under 3 years old.
4. To prevent possible short circuits, never touch the contacts inside the battery case with any metal.
5. Only install batteries after the kit is assembled. Adult supervision is required.
B. USE OF BATTERIES
1. Requires two 1.5V AA batteries (not included).
2. For best results, always use fresh batteries.
3. Make sure you insert the batteries with the correct polarities.
4. Remove the batteries when not in use.
5. Replace exhausted batteries straight away to avoid possible damage to the kit.
6. Rechargeable batteries must be removed from the kit before recharging.
7. Rechargeable batteries should be recharged under adult supervision.
8. Make sure that the supply terminals in the battery case are not short circuited.
9. Do not attempt to recharge non-rechargeable batteries.
10. Do not mix old and new batteries.
11. Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
C. CONTENTS
1
4 5
Part 1: Base, Part 2: Battery cover, Part 3: Base cover, Part 4: Bottle holder, Part 5: Motor with water-resistant ring installed, Part 6: Propeller,
Part 7: Terminal cap x 2 pcs, Part 8: Screw x 6 pcs, Part 9: Foam ball pack, Part 10: Sticker, Part 11: Bottle. Also required but not provided: a
small crosshead screwdriver, 1.5V AA battery x 2.
D. ASSEMBLY
1
5
1. Thread the motor wires through the holes in the base cover as shown. Push the motor, with the spindle facing up, into the opening of the base cover.
Around the motor spindle there should be a red water-resistant ring. The spindle has been treated with water-resistant oil, and may be slightly greasy.
2. Place the bottle holder over the motor and use two screws to secure it. Be sure to screw them in tight: there should be no gap between the
bottle holder and the base cover.
3. Turn over the base cover so that the ON/OFF switch opening is face-down. Place the base next to the base cover, with the ON/OFF switch
pointing towards it. Take a wire from the motor and the same coloured wire from the battery case and insert both into one of the terminal holes
next to the switch. Secure both wires with a terminal cap. Repeat with the other two wires in the other terminal hole.
QUESTIONS & COMMENTS
We value you as a customer and your satisfaction with this product is important to us. If you have comments or questions, or you find any
parts of this kit missing or defective, please do not hesitate to contact our distributor in your country. You will find the address printed on the
package. You are also welcome to contact our Marketing Support Team: Email: infodesk@4m-ind.com, Fax (852) 25911566, Tel: (852)
28936241, Web site: WWW.4M-IND.COM
Tornado Maker
2
6 7
x 2
8
x 6
2
3
3
10
9
4
11
3
7
1