Venture Lighting WP27392 User Manual

U M
V L L E D W F
SER ANUAL
E N T U R E I G H T I N G ' S A L L P A C K I X T U R E
STOP
Before You Begin
Read These Instructions Completely and Carefully
Installation Using Mounting Brackets
1: Disconnect power from the luminaire and follow proper lockout/tagout procedures before beginning installation or maintenance.
2: Remove the existing luminaire. Dispose of the existing lamp(s) and ballast(s) per local requirements.
3: Loosen the screws on the side of the fixture. (Figure 1)
4: Open the fixture and disconnect the quick disconnects which connect the LED driver to the LED module. (Figure 2)
5: Drill mounting installation holes needed for the installation into the back of the fixture. (Figure 3)
6: Loosen the plug on the back of the fixture, route the wiring through the hole and mount the back of the fixture to the junction
box. (Figure 4)
7: Connect the supply wires to the fixture input wiring.
8: Connect the quick connect terminals which were removed in Step 4.
9: Secure the fixture closed by tightening the screws on the side of the fixture. (Figure 5)
10: Power can now be restored to the system.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
(800) 451-2606 VentureLighting.com