FOCO FGE-HR-300W4000K Installation Instructions

INSTALLATION INSTRUCTION
Parameters
Input Voltage
Part No.
FGE-HR-300WYYK
FGE-HR-400WYYK
FGE-HR-500WYYK
FGE-HR-600WYYK
AC100-277V
FGE-HR-800WYYK
FGE-HR-1000WYYK
FGE-HR-1200WYYK
FGE-HR-300WYYK
FGE-HR-400WYYK
FGE-HR-500WYYK
FGE-HR-600WYYK AC277-480V
FGE-HR-800WYYK
FGE-HR-1000WYYK
FGE-HR-1200WYYK
YYK represents the CCT: 4000K, 5000K, 5700K.
Cautions:
1 Can not use the electric generator to test the LED lamp.
2 Please abide by related country, regional and local law and regulations when install this fixture.
3 To avoid electrical shock and damage, please do not install the lights in raining days.
Notices:
1 To prevent from electric shock or fire risk, the installation must be conducted by operator who have
professional electrical knowledge.
2 Please wear gloves to avoid injury before installing lamps.
3 During or after installation, if there are situations such as smoke, fire in the wires or lamps, please
turn off the power immediately and notify relevant personnel of an overhaul.
Installation - surface mounting:
1. Please find a professional to install the LED sports light.
2. lamp installation and wiring must be operated in case of power failure.
3. Do not disassemble any part of the fixing device.
4. Please do not use corrosive solution to clean the LED sports light. Please use a dry rag.
5. Please refer to the lamp label for product specifications.
Installation Instruction：
1. Align the holes of the bracket with the mounting
holes already reserved on the wall, put on the flat
washers and spring washers，Bolt. Tighten the bolt
to lock into the wall (upside or front-side)
Lock into upside Wall
bolt
spring washer
flat washer
Frequency Power
Rated Current
300W 3.3A
400W 4.4A
5.5A
500W
600W 6.6A
50/60Hz
800W 8.8A
1000W
11A
1200W 13.2A
300W 1.19A
400W 1.59A
500W 1.99A
50/60Hz 600W 2.38A
800W 3.18A
1000W 3.97A
1200W 4.77A
2. Loosen the bolts and screws on both sides with
a wrench and allen wrench, turn the fixture to the
proper angle, then tighten the bolts and screws
back to finish installation.
Lock into upside Wall
screws
allen wrench
wrench
bolt
3. Wiring Diagram: Input wire (three cores): black,
white, green Dimming wires: (two cores): purple, gray
Lock into upside Wall
purple DIM+
gray DIM-
black L white N green
Lock into front-side Wall
wrench
allen wrench
bolt
screws
Installation Instruction( mounted on the light pole )
1. Make the bracket face aim to the installation hole ,put
on the flat washer, spring washer and screw bolt, screw
the nut from bottom to top.
Lock into front-side Wall
flat washer
spring washer
bolt
Lock into front-side Wall
purple DIM+
gray DIM-
black L white N green
2. Fasten the screw nut clockwise with provided wrench.
wrench