HAMPTON BAY L08557-BK Use And Care Manual

PIease read and save these instructions。
Use and Care Guide
RGBW LED SPO丁」音GH丁
RACKAGE OONTE‖TS
y and InstaIlation
Pa嶋 Description Quantity
A Light 1
B Spike 1
C Connec青0r 1
盆cÅUT‑O帽e for outdoor o叩tion"
△器器蕊t OPerate the fuminaire frmng w柵a missing oγ damaged lens
△ v脚NG咽麹‑I in ac∞rdan∞ Wi咽i locaI code§ and ordinances・
OnIy fo「 use with low voltage powe「 units with a maxjmum output rating of 12V
300W per secondary.
FOR 」ANDSCAPE 」iGHTきNG SYSTEMS ON寡Y. OUTDOOR USE ONIJY: THE DEVICE IS
AcCEPTED AS A COMPONENT OF A 」ANDScAPEしIGHTING SYSTEM WHERE THE
SuilA即しITY OF THE COMBINÅTION SHAし」 BE DETERMINED BY CSA OR LOCAL
INSPEcTION AuTHORITiES HAVING JuRISDiCTION,
ETしLISTED UNDER MODE」離しO8557,
1 A鴨ching and instailing the l冒ght
△満精霊器誤露語悪罵諾nd byt剛ght ㈹ o「 use a
口Carefully remove the fixture from its protective packaging.
ロA請ach spike (B) and light仏) together by tu「ning them
anti cIockwise.
2 comecting the wires
△善書薬篭諾龍盤諾霊語群詫誓霊慧9仇e
△豊富嵩誓霊hock lnstall a"一umina煽lOft華O5 m) ol mOre
総譜器精霊霊蕊蒜認諾:n闘‑ be 12￣18飾G昨
⑥:...輩撃紫‑書架書芸霊芸a
undergrassatamax〃mumdepthof61n.15.24cm,
.Donotsubme喝efixtureinwate青
□ AIign the iow‑VOitage wire and fit it into the comector bottom
haIf as shown beiow,
口Press the top half of請e connector into the bottom ha晴unti帽cIicks
into pIace and is secure, This wiII pierce the Iow vo鵬age wire and
connect the Iight to the transfomer,
ロTest the connection by plugging in the transformer to see if the Iight
tums on. 1f鵡does, unpIug the請ansfomer and continue the instaII葛
a噛on. if it does not, unPIug the transfomer and check飢e connec‑
tion between the transfomer and iow‑VOltage wire, reinstalI帥e
connector, and ensure power is availabIe to the outlet you are using,
ロOnce the connection is secure, rePeat the process fo「 the remaining
Iights,
□ Once aI=ights are connected,師S recOmmended to W.ap each con‑
nector w請1 eIectrical也pe for additionai p「otection,
□ A請e「 ail fixtures are instaIIed, tum On the廿ansfomer by pIugging韓
into an outlet.
ロNote: lf you want to instaII皿s w鵡h your existing iow‑VOltage Iig州ng
SyStem, Skip step 4 and ins章ead pIug the lights into your exis噛ng
18AWG to 1 2AWG SPT‑2W wiring,
‑1一