BUILDPRO TM Series Setup Instructions

MODULAR WELDING TABLE SETUP INSTRUCTIONS
Applicable P/N: TM, TMQ series.
Thank you for choosing BuildPro
setup instructions before beginning the setup of your BuildPro® Welding Table.
TABLE SETUP
1. First remove the wooden table cover,
bubble film and anti-rust paper, then use
the forklift to lift the whole table. (or use
other lifting equipment) Remove the
supporting (shipping) legs (4 or 6) based
on the size of the table.
2. Place the yellow table legs into the same
screw holes originally used to secure the
shipping legs, then tighten clockwise with
a screwdriver or a round bar smaller than
12 mm (Figure c)
small through-hole in the middle of the
yellow legs.
3. After the table legs are securely installed,
lower the table onto your shop floor.
4. Adjust the Leveling Nuts on each Leveling
Pad until the entire table is level. Tighten
the lock nuts using a wrench.
1.562.949.8625 | www.stronghandtools.com | sales@stronghandtools.com | 8750 Pioneer Blvd., Santa Fe Springs, CA 90670 U.S.A.
Modular Welding Tables. Please read all
®
(Figures a & b).
by inserting into the
(Figure d)
BUILDPRO
(a)
Packaging Supporting Legs
(b)
Screw Driver
(c)
Leveling
M20
(d)
Pad
Nut
®
Welding Tables
Round bar