Advertisement
Quick Links
Next Gen/Ultimate Car Shield/Bike Shield
Big Box: Next Gen /Ultimate Car/Bike Shield and ...
•
Fans, Panel, AC Adapter & Plug
•
Fan Cover Support (Outdoor version only)
•
Air Filters & spare material
Small Box: Accessories
•
Air Pump and tubes
For further information on care and warranty:
I
n the Garage AG – Zumikerstrasse 24, Zollikon 8702 Switzerland (V. 12/04/22)
What's in the Box
www.inthegarage.com/instructions
1 / 7
Advertisement
Related Manuals for In the Garage Next Gen
Summary of Contents for In the Garage Next Gen
- Page 1 Next Gen/Ultimate Car Shield/Bike Shield What’s in the Box Big Box: Next Gen /Ultimate Car/Bike Shield and … • Fans, Panel, AC Adapter & Plug • Fan Cover Support (Outdoor version only) • Air Filters & spare material Small Box: Accessories •...
- Page 2 WARNINGS Do not overinflate or interfere with the pressure settings which are pre-set from the factory Should the Air Pump run for over 30 minutes, switch it off. There is a risk of pump overheating/burn out/fire. Risk of suffocation/asphyxiation if persons are inside the device– do not leave children unattended.
- Page 3 Instructions Note: It should take about 20 minutes to set up the Ultimate Car Shield/Ultimate Bike Shield once unpacked. We recommend two people. Only products marked “Outdoor” are for use outdoors. All other products are for indoor use only! 1. Unfold the Ultimate Car/Bike Shield and place it where it will be located when inflated. For the first inflation, connect to exterior set of valves 2.
- Page 4 Notes: • This system allows constant maintenance without any user intervention in the event of pressure drops common to all inflatable products • You may need to assist the device by lifting the pillars during inflation to ensure a smooth rise. If it is not fully inflated at five minutes, turn off the pump and unfold any portions which may be blocked or stuck together •...
- Page 5 8. Install the Fans by placing the Velcro panel on the inside of the Ultimate Car/Bike Shield. Press hard 9. With the AC Adapter outside the device, run the power wire through the purpose-made slit and connect to Fan. (do not plug in an electrical socket yet as you first need to install the Filter) 10.
- Page 6 11. Snap on the corresponding plug Adapter for your region onto the AC Adapter 12. Plug the AC Adapter in an appropriate electrical power socket 13. Outdoor version: Install the Fan Cover Support inside the hood above the fans 14. ATTENTION: Outdoor version: Anchor the device to the ground (refer to Warnings & Care for more information) 15.
- Page 7 CARE / TROUBLESHOOTING 1. Use gentle soap and water to clean the PVC 2. Avoid contact between hot vehicle exhaust and PVC 3. Holes can be repaired using the patches supplied together with adhesive (i.e. TEAR-AID Type B) 4. Wash the charcoal filter with soap and water regularly (approx. every 6 months) depending on local region / air quality 5.