Javad 99-587303-01 Instructions

UHF Whip Antenna 5/8, 5dBd, NMO
[99-587303-01, 99-587304-01, 99-587305-01, 99-587305-20, 99-587305-30, 99-587305-40, 99-587305-50]
High performance 5dBd gain antenna for HPT435BT and HPT404BT transceivers
High Performance: A full 5dB gain is achieved in this antenna by featuring a 5/8 wave over 5/8 wave
whip with a base loaded matching coil. It has a power handling capacity of 200 watts.
Stylish and Durable: This antenna is manufactured using the finest corrosion resistant materials and
finishes available. The base is triple plated chrome brass with an insert molded low loss coil form and
a spring loaded contact. The silver plated phasing coil is fully enclosed to insure years of dependable
service.
Weatherproof: O ring seals and overlap construction keep moisture out of the antenna.
Antenna requires a good ground plane for optimum performance. Poor ground planes and improper mounting position
may cause less than optimum results.
An UHF Antenna Ground Plane Disk (p/n 10-587400-01) should be installed at the bottom of the antenna if 12ft/3.6
m antenna cable p/n 14-578117-06(05, 07) Accessory UHF Ant Cable TNC (BNC, SMA)/NMO with pole mount antenna
adapter is used.
If the antenna is mounted on the metallic surface (a car roof or a plate of iron or steel) using magnet mount adapter, it
would substitute the Disk.
Optional 12ft/3.6 m antenna cables with magnet mount type of mounting adapter are p/n 14-578115-02 (01) Accessory
UHF Ant Cable TNC (BNC)/NMO with standard magnet mount adapter and p/n 14-578116-02 (01) Accessory UHF Ant Cable
TNC (BNC)/NMO with Mini-magnet mount adapter.