MAGNITUDE LIGHTING E Series Installation Manual

E-SERIES RECOGNIZED
FOR MODELS
E20R12DC, E40R12DC, E60R12DC
General
This driver is to be installed in accordance with Article 450 of the
National Electric Code. The driver must be installed in a well-ventilated
area free from explosive gases and vapors. Proper operation requires
for free flow of air. This driver should only be installed by a qualified
electrician.
Precautions Before Installing
Check the label and ensure the driver has the proper input voltage and
wattage for the job. Check the wire markings to ensure they match the
wiring diagram on this installation guide.
Mounting
Select a suitable location capable of supporting the weight of the
driver. Use the two key holes in the wire housing and third hold on the
flange when mounting. It is recommended that the driver be mounted
vertically with the wiring compartment pointing down. Recommended
spacing between drivers is 5".
Mounting
Holes
5" Min.
Spacing
Mounting
Holes
Magnitude, Inc.
14711 Bentley Circle. Tustin, CA 92780
Quick Specs
Input Voltage
Output Voltage
Max. Ambient Temp.
Enclosure
Min. Installation Space
Between Drivers
www.MagnitudeInc.com
INSTALLATION GUIDE
E-SERIES
120VAC / 12VDC
120V AC
12V DC
-300 C to 400 C (-22°F - 104°F)
IP67 Wet Location
5" Inch
technical@MagnitudeInc.com
Page 1 of 2
DOC-GU-00002A Rev. 1