Advertisement
Quick Links
Advertisement
Related Manuals for Nitrox Sprinter 12
Summary of Contents for Nitrox Sprinter 12
- Page 1 User manual Electric Balance Bike Nitrox Sprinter 12-16...
- Page 2 Contents 1. Cautions 2. Vehicle structure 3. Bike Assembling 4. How to use. 5. Daily maintenance Cautions 1. Note: the product pictures are for illustration purpose only. These pictures may not reflect the exact out looking of actual product. Specifications may change. Before using the bike, please read the manual carefully and inspect whether the parts are in good conditions to ensure children and riding safety.
- Page 3 3. The bike should be parked in a dry and ventilated place. Do not rinse the bike with water. It is recommended to wipe it with a cloth. 4. Please comply with local laws or regulations: Please slow down and increase the braking distance in rainy/ snowy weather or on slippery roads to sure the safety.
- Page 4 Bike Assembling 1.Please take out the bike from carton, remove the packing and fix the handlebar on the stem tightly with a hex wrench. 2. Installation requirements 2.1 Handlebar needs to be symmetrical 2.2 Correct the horizontal angle, the brake level is about 15°horizontally...
- Page 5 3. Front wheel installation 3.1 Take the front wheel assembly from the packing box and place the front wheel into the front fork as shown in the figure. 3.2 Lock the left and right nuts of the front wheel with a 15# wrench and check whether the front wheel is rotating flexibly.
- Page 6 4. Use the finger to push the throttle to control the power 5. Speed conversion instructions In order to protect children and prevent riding speed from being too fast, the figure below shows the controller plug-in connection speed limit line. The plug-in speed limit line is disconnected and turned on to realize two speed modes.
- Page 7 Daily maintenance 1. Chain loosing: adjust the jack screw to adjust the chain. 1) Loosen the nuts on both sides of the rear shaft with a 15# wrench. 2) Tighten the jack nut with a 10# wrench, check the tightness of the chain, press the middle part of the chain with your finger, the up and down movement amplitude of the chain is 10-12mm, then lock the nut at both ends of the rear shaft.
- Page 8 4.charging battery：please open the waterproof cover of charging port，plug the charger DC head into charging port and fit the plug to the power supply. 5.Adjusting the saddle height： the seat post is prohibited from exceeding the security line. 6.Lubrication is an important part of the maintenance of electric balance bicycle. The front axle, rear axle and sprocket should be scrubbed every six months.