PacLights FALC/2 Series Installation Manual

INSTALLATION GUIDE
FALC/2-150
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
PacLights fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required for safety.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR
WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNINGS:
• Make certain power is OFF before installing or maintaining fi xture. No user serviceable parts inside.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sharp objects.
CAUTION:
• For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened fi rmly. Apply weatherproof silicone
sealant around the edge of the Back Box and/or Junction Box. This is especially important with an uneven wall surface. Silicone all plugs and
unused conduit entries.
FIELD-ADJUSTABLE LUMEN OUTPUT/WATTAGE
The Wattage can be adjusted with the Wattage Switch located
1
inside of the FALC/2 fi xture. The FALC/2-150 can be adjusted to
80/100/120/150W, the FALC/2-240 to 170/200/220/240W, and
the FALC/2-310 to 240/260/280/310W. Remove the Driver Cover
Screws (2) and open the Driver Cover to adjust the Wattage (Fig. 1).
WATTAGE
SWITCH
FIG. 1
WIRING DIAGRAM
Connect the ACL and the ACN from the FALC/2 Fixture to the conduit with the AC power Supply Cable. Follow the Wiring Diagram provided.
AC POWER SUPPLY
PL-INST-FALC/2-v0
FALC/2 Series LED Area Light
SURGE
PROTECTOR
FALC/2 FIXTURE
DRIVER
COVER
SCREWS
HOT [BLACK]
NEUTRAL [WHITE]
GROUND [GREEN]
Need help? (800) 988 -6386 Email: CS@PacLights.com Website: www.PacLights.com
Instructions and specifi cations are subject to change at any time without notice. Copyright© 2022 PacLights All Rights Reserved
FALC/2-240
IMPORTANT
The Lumen output of the FALC/2 fi xture can be adjusted simply by
2
moving the Switch to the desired Wattage (Fig. 2).
FIG. 2
FALC/2 DRIVER
FALC/2-310
WATTAGE
SWITCH
DIM
Page 1 of 4