Advertisement
Quick Links
1
SINGLE COLUMN LABEL
VIEW CONFIGURATION
BUOYANT
CABLE WINE STORAGE CONCEPT
www.buoyantwinestorage.com
FLIP THE WALL MOUNT
Flip the wall mount so that the small holes point
toward the ceiling, and large holes point
downward.
PLEASE NOTE: THIS POSITION OF THE WALL
MOUNT ONLY APPLIES WHEN INSTALLED AS A
BOTTOM WALL MOUNT.
1
Advertisement
Summary of Contents for Buoyant WM1L1
- Page 1 SINGLE COLUMN LABEL VIEW CONFIGURATION BUOYANT CABLE WINE STORAGE CONCEPT www.buoyantwinestorage.com FLIP THE WALL MOUNT Flip the wall mount so that the small holes point toward the ceiling, and large holes point downward. PLEASE NOTE: THIS POSITION OF THE WALL MOUNT ONLY APPLIES WHEN INSTALLED AS A BOTTOM WALL MOUNT.
- Page 2 INSERT CABLES INTO BOTTOM BRACKET Insert all 4 crimped cables through the small holes on top of the bottom wall mount bracket and pull them through the large holes on the bottom. ASSEMBLE BOTTOM ANCHORS Mount the male piece of the anchor(FM2) on the cables along with the spring(FM3) and FM4.
- Page 3 SLIDE ANCHOR ASSEMBLY Slide the anchor assembly inside the large holes of the bottom wall mount. NOTE: Anchor assembly should only extend 2mm below the bottom wall mount as shown below. SECURE BOTTOM BRACKET TO THE WALL Before you pull down your installer can draw a level line on the wall to ensure that the wall mount screwed into the wall leveled.
- Page 4 CUT CABLES Cut cables below the bottom wall mount. Be sure you do not cut the cable too short. NOTE: Use cable cutter to cut cable. COMPLETED BOTTOM MOUNT ASSEMBLY Proceed to the main Installation Guide and follow the POSITION EACH SHELF step.