Waterous K Series Operation And Maintenance Instruction

Download this manual

Read through the Operation instructions carefully

before using your Waterous Transmission.

NOTE: Instructions subject to change without notice

Waterous Company, 125 Hardman Avenue South, South St. Paul, Minnesota 55075 USA (651) 450-5000

K, T, TK, TA and KC Series

Operation and Maintenance Instructions

Introduction ........................................................................................... 1

K Series Transmission . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

T, TA Series Transmission ................................................................... 1

TK Series Power Take-Off .................................................................... 1

Tachometer Drive . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

Maintenance ......................................................................................... 2

Lubrication ............................................................................................ 2

General Description for KC Series ..................................................... 3

Tachometer Drive . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Operating Instructions for KC Series ............................................... 3

Maintenance ......................................................................................... 4

Hydraulic Fluid Repair ........................................................................... 4

www.waterousco.com

F-1031, Section 2206 (Revised: 3/13/20)

Page 1: Table Of Contents
K Series Transmission ........
Page 2: Introduction
T, TA Series Transmission This case is identical to the K series, except that it includes a bell housing flange and the proper drive shaft for direct mounting on an engine bell hous- ing.
Page 3: Operating Instructions For K, T , Tk & Ta Series
(Under severe service conditions, where pump has been used continuously at high output, change oil more frequently.) The capacity is approximately one quart. Be sure to clean drain plug and breather. Figure 1. K Series Transmission Figure 2. T Series Transmission Figure 3. TK Series Power Take-Off Figure 4.
Page 4: General Description For Kc Series
(P/N MS3106A-10SL-4S). This connector may be wired to a wall mount re- (Hz) x K = RPM ceptacle on the operator's panel with a cable available from Waterous Com- pany. The number of teeth on the driven gear (pulse generator) varies with the dif- ferent gear ratios and affects the frequency that the tachometer picks up.
Page 5: Maintenance
Maintenance An oil splash system, within the gear case, lubricates the gears and other To add oil, remove filler plug or breather at top of gear case, and pour oil moving parts. Check oil level monthly by removing the square head pipe through opening until oil comes out the oil level hole.

T seriesTk seriesTa seriesKc series

Table of Contents