A LED Brida Operating Manual

4. Contact an authorised technical service centre for any repairs possibly required use only original spare parts.
5. Do not touch LED while installing or maintaining.
6. Sealing the entrance hole with glue after install is needed.
7. The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a
similar qualified person.
Instruction for Light Source Disassembly
1
Unscrew the diffuser anticlockwise and vertically
take it out.
3
On the reverse of diffuser, use the screwdriver to
pry the clips to release the PCBA, then twist the
PCBA anticlockwise.
* This product contains a light source of energy efficiency class <D>
IP65 IK10
A LED A/S Hammeren 6, DK-6800 Varde www.aled.dk +45 71995354
2
Disconnect the DC power cable from the driver.
4
Take out the PCBA (light source) from the diffuser.
RoHS
OPERATING MANUAL
Brida - Sensor CCT
Important: Please read the instruction manual carefully prior to installation and keep it for future reference.
Product Power
Function
Ordering Code
(W)
Description
Fitting Series
Sensor DIM,
Brida Sensor CCT color temperature
Brida 18
Hvid / Sort selectable, power
switchable
Accessories
No. Pic. Qty. Usage
1 3 Fix light
2 3 Rawl plug
Vandal proof
1
3
screw tool
4 3 Plastic washer
5 2 Fix cable clip
6 1 Cable clip
7 1 Cable clip
8 4 Plastic plug
Installation
1
Unscrew the diffuser anticlockwise.
Vertically remove the diffuser and PCBA.
55
290
Mounting: Wall or Ceiling
Light features:
Ra: >80
Life Time: 5 years
Light Source: LED SMD2835
Input: 220V-240V 50/60Hz
C0/180,110.1 C60/240,109.5
C30/210,110.5 C90/270,108.9
CCT:
1 2
Power
Electric Current
I
3000K
300mA 11W
II
3500K
350mA 13W
1 2
III 4000K
500mA 18W
Colour Temperature Code
Lumen
Code Colour Temperature CCT(K)
Hvid Sort
30K Warm White 3000 2070 1980
35K Natural White 3500 2160 2030
40K Cool White 4000 2196 2070
2
a. Cut off the power. Thread the input cable through the
rubber plug to the fixture. Connect the L, N wire
referring to the wiring diagram.
b. Knock the rawl plugs into the pre-drilled holes on ceiling
/wall. Wear plastic washers on self-tapping screws and
tighten them to fix the fixture on ceiling/wall.