Bracketron PwrUp Clean BT2-712-2 Quick Start Manual

PLEASE READ INSTRUCTIONS COMPLETELY BEFORE USING THIS DEVICE
A
PRODUCT PARTS AND CONTROLS
Ultraviolet light
Power input
Aromatherapy socket
PwrUp Clean
Wireless Phone Charger and Sterilizer
BT2-712-2/BT2-751-2
IMPORTANT NOTE
AROMATHERAPY button
Wireless charging area
Progress indicator lights
DISINFECTION button
B
1. Plug it in: Plug the Micro-USB end of the included power cable into the back of the PwrUp Clean. Plug the other end into a
TM
standard 110V household electrical outlet.
2. Insert device: Open the lid and set your phone (face up) inside the housing. For speci c phone models that can charge
wirelessly, be sure that your phone is centered inside the PwrUp Clean. You will know your phone is aligned properly when
the phone starts to charge. Charging time for your phone will vary, depending on your phone's battery level. (It is not
necessary to run the sterilization process in order to charge your phone.)
3. Sterilize: With the phone inserted in the housing, close the lid and press "DISINFECTION" to begin the ultraviolet sterilization
process. Status indicator will show the progress of the sterilization process, which takes 5-10 minutes. Once the sterilization
process is complete, open the lid and remove your device. Or, after the sterilization process is complete, you may let your
phone continue to charge in the housing for as long as necessary. Note: We do not recommend opening the lid or removing
your device prior to the completion of the sterilization process.
4. Aromatherapy: Open the lid and add a few drops of aromatherapy essential oil (not included) to the aromatherapy socket
in the upper left corner of the housing. Then set your phone in the housing, close the lid and press "AROMATHERAPY". The
aromatherapy process takes 5-10 minutes.
C
• A soft cloth or a paper towel may be used to clean this device. Unplug the device from its power source before
cleaning. Do not use excess water or any kind of cleaning solvents when cleaning the device.
• Keep the device away from re sources, wet or high-moisture conditions, and corrosive or ammable chemicals.
• Close the device's lid before starting the sterilization cycle and keep the lid closed during the entire sterilization
cycle. Do not look directly at the ultraviolet lamp when illuminated.
For more information, please visit www.Bracketron.com
HOW TO USE
CARE AND SAFETY INFORMATION