NICOR ECL21UNVWHR2 Installation Instructions

WARNING
- Risk of fire or electric shock. LED installation requires knowledge of luminaires electrical systems. Review the diagrams thoroughly
before beginning. All electrical connections must be in accordance with local codes, ordinances, and the National Electric Code. If
not qualified, do not attempt installation. Contact a qualified licensed electrician.
- Before installation, disconnect the power by turning off the circuit breaker or by removing the appropriate fuse at the fuse box.
Using the light switch to turn power off is not sufficient to prevent electrical shock.
- Do not use outdoors.
- Do not let power supply cords touch hot surfaces.
- Do not mount near gas or electric heaters.
- Use caution when servicing batteries, all servicing should be completed by qualified personnel. Replace every 8 to 10 years
according to ambient. Test regularly in accordance with local codes.
- To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
- Do not use this equipment for other than its intended use.
- The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
- Equipment should be mounted in locations and at heights where it will not be subjected to tampering by unauthorized personnel.
- Operating temperature: -15°C - 40°C.
- Allow batteries to charge 24 hours before first use.
What's In The Box
One (1) ECL2
Installing the ECL2
Preparation
1
Carefully unpack the exit light from its packaging. Inspect product for defects due to shipping. Become familiar with
the wiring diagram below before beginning installation. Take the faceplate off of the fixture and remove the plastic
diffuser. Remove the appropriate chevron arrow knockout and replace the plastic diffuser. If using double face option,
remove the appropriate chevron arrow of the second faceplate. Set the faceplate(s) aside.
NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com December 10, 2019 11:33 AM
ECL2
One (1) Mounting Kit
Figure 1 - Wiring Diagram
Slim LED Combo Exit Sign & Emergency Light
INSTALLATION INSTRUCTIONS
Model: ECL21UNVWHR2, ECL21UNVWHG2
Tools Needed
A Phillips screwdriver will be needed to install the
ECL2. A drill is needed to remove the knockouts if
back mounting.
Make sure all power is turned off before beginning installation
Figure 2 - Chevron Arrow
Removal