Nabco U19 Quick Start Manual

SERVICE PARTS: TELESCOPIC KIT
U19 FAIL SECURE: P/N A 01228
U19 FAIL SAFE: P/N A 01229
Harness, Handing
Microprocessor
P/N M-01190
Nut, Wire, Range
22-14AWG, Grey
P/N T-00197
Relay Asm, E.Lock; U19
Fail Secure P/N A-00780
Fail Safe P/N A-00781
Attention: Electric Locks can not prevent Breakout. If preventing Breakout is deemed necessary, panic hardware
must be fitted to the Door Panels.
CHAPTER 1: REPLACE THE BELT CLIP
1. Use the same hardware from the existing Belt Clip to replace the existing Belt Clip with the Electric Lock Belt Clip.
CHAPTER 2: INSTALL THE ELECTRIC LOCK
1. Fully Close the Lead Door. Go to the Latch located on the Electric Lock Belt Clip.
2. Align the Center of the Latch to the front face of the Box Beam. Mark that spot.
Marked Spot
Front Face
of Box Beam
All manuals and user guides at all-guides.com
Nabco Entrances Inc. S82 W18717 Gemini Drive Muskego, Wisconsin 53150
Phone: (877) 622-2694 Fax: (888) 679-3319 www.nabcoentrances.com
NABCO hours of Operation: Monday to Friday 8:00 a.m.- 4:30 p.m. (Central Time)
Rivnut
1/4-20, .027-.165
P/N T-00048
Washer, Lock, 1/4"
P/N T-00087
Carrier
Lead Door
Elec. Lock Bracket
GT1175 Telescopic, U19 Electric Lock Kit
Instruction Sheet
P/N C-00336 Rev 3-15-18
Hex Head Screw
1/4-20x.750L
P/N T-00064
Riv Nut
Figure 1 Install the Electric Strike and Electric Lock Belt Clip
Electric Strike, Telescopic
Fail Secure: P/N A-00293
Fail Safe: P/N A-00294
Bracket, Elec.
Lock Repl.Kit
P/N A-01224
Parts Bag,
Elect. Lock U30 Telesc.
P/N A-01225, Fail Secure
P/N A-01226, Fail Safe
Electric Lock
Lock Washer
Strike
Hex Head Screw
DN 1966
DN 1964
1 of 3