OFM Stimulus 521-LX Assembly Instructions

Model 521-LX / 521-LX-AA
Parts Listing
B
A
Chair Back Chair Seat
1 Unit 1 Unit
C D
Chair Base Seat Mechanism
1 Unit 1 Unit
E F
Gas Lift Telescopic Bellows
1 Unit 1 Unit
G H
Casters 8x25mm Screws
5 Units 7 Units
I
Allen Wrench
1 Unit
Stimulus Leatherette Mid-Back Chair
1
F
E
C
G
WEIGHT CAPACITY: 250 lbs.
Assembly Notes:
During assembly, hand tighten screw only when all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
STOP
Please read all instructions before assembly.
Step 1: Insert Casters (G) into Base (C). Insert Gas Lift (E) into Base (C),
and cover with Telescopic Bellows (F).
Step 2: Place Chair Seat (B) upside-down on a level, non-abrasive
surface and align pre-drilled holes in Seat Mechanism (D),
with holes in Chair Seat (B). Insert four 8x25mm Screws (H)
through the holes in the Seat Mechanism (D) and into the
Chair Seat (B). Tighten with Allen Wrench (I) provided.
If you are assembling a model with optional Adjustable Arms please
STOP
proceed to subsequent pages for armrest assembly instructions.
Step 3: Connect Chair Back (A) to Chair Seat (B) by inserting the J-bar on
the Chair back into the back of the Seat Mechanism (D), Then attach
with three 8x25mm Screws (H) using the Allen Wrench (I) provided.
Step 4: Carefully place Chair Seat (B) with attached Seat Mechanism (D)
onto the Gas Lift (E) by aligning the hole in the Seat Mechanism (D)
with the top of the Gas Lift (E). Carefully sit on chair to make sure
the Gas Lift (E) is properly inserted into the Base (C). Operate the
Gas Lift Lever on the Seat Mechanism (D) to be sure unit is working.
2 3
I
B
H
B
D
06.10.2010
I
4
H
D
A
161 Tradition Trail Holly Springs, NC, 27540
800-520-7471 (voice)
919- 303-6389 (voice)
support@ofminc.com
919-362-4765 (fax)
www.ofminc.com