Advertisement
Quick Links
ROTATING PRESS SIMPLY 5S-6S
A Movement machine lever
B Locking seal capo of finished shell
C Finished shell height regulator
D Locking seal cap engraver height regulator
E Engraver height regulator
F Crimper pre closure height regulator
H Regulating seal cap for powder and lead dosers
I Rotating disc
L Wadding guide
M Wadding pushers
N Maneuvering lever regulator
O Powder and lead tank closure taps
P Powder tank
Q Lead tank
R Cartridge case oiling sponge
S Hemmer head
T Micrometric scale
Z Open-close selector powder-lead with safety block
Advertisement
Summary of Contents for OMV SIMPLY 5S
- Page 1 ROTATING PRESS SIMPLY 5S-6S A Movement machine lever B Locking seal capo of finished shell C Finished shell height regulator D Locking seal cap engraver height regulator E Engraver height regulator F Crimper pre closure height regulator H Regulating seal cap for powder and lead dosers...
-
Page 2: Installation
The press was designed trying to make it very simple in the initial adjustment and in use during loading, in fact, once you have acquired the necessary experience, a few simple operations are enough to change the gauge and adjust the machine. The powder and lead dosing system is performed by means of a dosing bar and micrometric knobs for adjusting the doses;... - Page 3 ENGRAVING DEPRIMER HEMMING Description of work phases SIMPLY 5S version Station N.1: Insertion of a new case for powder entry Station N.2: Wad insertion and wad pusher Station N.3: Lead dose insertion Station N.4: Engraving station Station N.5: Hemming and closing of the cartridge then ejection...
- Page 4 PHASE 1 First of all, make sure that the taps of the tanks are closed in a horizontal position and fill the right tank with lead and the left one with powder; also the selectors placed underneath must be closed in the closed position, and the safety knobs must also be blocked so that when the machine is moved, nothing can escape from the nozzles. Now we can adjust the hemming height, insert a new empty case in any station and rotate the disc manually until it is in position (N.5 for 5S press) (N.6 for 6S press) turn on the motor and lower lever A as far as it will go, to create a round hem.
-
Page 5: Maintenance
After first loosening the nut of the regulator M, screw the pusher bar all the way up, operate the control lever as far as it will go, and keep it forced in that position; at this point let the pusher go down by unscrewing it until it rests on the wad and lock the nut. It is important that the wad comes to rest on the powder. LOADING A USED SHELL CASE. - Page 6 NOTES TO READ * When choosing the case, bear in mind that a flared case must be used for the star closure, while it must not be flared to make a round rim. * Be careful if during the loading cycle we stop for a prolonged break or abandon work, take into account that the stop will have reopened the folds of the crimping station of the last cartridge.