KCVENTS FM-125-06 User Manual

Techn ical parameter
Item
Rated Rated Air
Voltage Frequency velocity
Model
(V) (Hz) (m/s)
FM-125-06 220 50/60 9-11
FM-125-09 220 50/60 9-11
FM-125-10 220 50/60 9-11
FM-125-12 220 50/60 9-11
FM-125-15 220 50/60 9-11
FM-125-18 220 50/60 9-11
FM-125-20 220 50/60 9-11
MAINTENANCE
To reduce the risk of fire, electrical shock or injury to persons, observe the following:
A. Maintenance is to be performed only by qualified personnel who are familiar with local codes and
regulations and are experienced with this type of product.
B. Before servicing or cleaning the product switch power off at service panel and lock service panel to prevent power
from being switched "ON" accidentally.
Routine maintenance is required to keep this product operating at its peak performance and efficiency. Over
time, the housing, air intake grille, air intake filter, blower wheels and motor(s) will accumulate a build up of
dust, debris and other residue. It is imperative to keep these components clean. Failure to do so will not only
lower operational efficiency and performance, but also reduce the useful life of the product. The time between
cleanings depends on the application, location and daily hours of use. On average, under normal use
conditions, the product should require a thorough cleaning once every six (6) months.
To clean the product, perform the following:
1. Verify the product has been disconnected from the power source.
2. Use a damp cloth and either a warm mild soapy water solution or bio-degradable degreaser, to wipe
down the exterior components of the housing.
3. To access the interior of the product, remove the air intake grille(s) and/or air intake filter(s). This i s
accomplished by removing the screws on the face of the air intake grille(s)/filter(s).
4. Thoroughly clean the air intake grille(s)/filter(s).
5. Thoroughly wipe down the motor, blower wheels and blower wheel housings. Be careful not to spray
the motor with a water hose.
6. The motor(s) require no additional lubrication. They are permanently lubricated and feature double
sealed ball bearings.
7. To re-install the product, reverse the procedures above.
8. Reconnect the power source to the product.
9. If you have any questions regarding the maintenance of the product, contact the manufacturer.
Air Input
Noise Unit Size
vulume Power
(dB) (mm)
(m³/h) (W)
850 50 120 600*145*185
1410 50 125 900*145*185
1500 51 145 1000*145*185
1930 51 160 1200*145*185
2630 52 190 1500*145*185
3180 52 240 1800*145*185
3510 53 280 2000*145*185
Air Curtain
NOTE:
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or
maintain the product described. Protect yourself and others by observing all safety information. Failure to
comply with these instructions could result in personal injury and/or property damage. Retain these
instructions for future reference.