olympia electronics RT-15 Quick Start Manual

ELECTRIC INSECTICIDES
RT-15
TECHNICAL CHARACTERISTICS
DESCRIPTION
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION 270VA
FLUORESCENT LAMP 3x36W BL
GRID VOLTAGE
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
CONSTRUCTION MATERIALS
EXTERNAL DIMENSIONS
13.6kgr.
TYPICAL WEIGHT
GUARANTEE
Thank you for your trust in our products
Olympia Electronics - European manufacturer
IN GENERAL
The device was created to exterminate all
disturbing insects. The special fluorescent tubes
(Black Light) attract insects from a long
distance. For this reason it could be used in
every place that many insects exist. They are
attracted and pass though the interior metal net,
they are exterminated by high voltage.
There is an exterior net in order to protect
birds, animals or human beings that are
close enough.
Without using any chemical material it offers
a c o m p l e t e p r o t e c t i o n a g a i n s t m a n y
insects like mosquitos, flies, tiny gnats etc.
There is a special drawer at the bottom
side of the device where all dead insects
a r e c o l l e c t e d . To r e m o v e t h e d r a w e r
unscrew the retaining screw.
WARNING!!!
B e f o r e r e m o v i n g t h e d r a w e r f o l l o w
carefully the below steps.
a. Remove the plug of the mains.
b. Unscrew the retaining screw of the
drawer.
c. Remove the special drawer, clean the
drawer and re- install it. Then screw
again the retaining screw and
reconnect the device on the mains.
In case of changing the lamps or the starter,
follow carefully the below steps.
a. Remove the plug of the mains.
b. Unfasten the retaining screws and
remove the protective exterior net.
c. Replace the tube or the starter which
Page 1 from 2
RT-15/2 RT-15/6
Electric insecticide Electric insecticide with mirror
220-240V AC/50-60Hz
150VA
2x36W BL
3.5kV
IP 20
EN 60335-1, EN 60335-2-59
o
0 to 60 C
Up to 95%
Bayblend FR3010, electrostatic painted aluminum
1250 x 140 x 480 mm (L x W x H)
12.9kgr. 13kgr.
2 years (1 year for the lamps)
is worn.
d. Reinstall the protective exterior net
and fasten the removed screws.
e. Finish reconnecting the device on the
mains and it is ready to operate.
AT T E N T I O N ! ! ! W h e n t h e d e v i c e i s
operating the protective exterior net must
be installed.
Installation
Just plug the apparatus to the mains and it is
ready for operation.
It is placed in a clear and visible place so
as to attract insects easily .
It includes two hooks on top side for ceiling-
mounting installation using a chain. The
RT15 and RT-15/2 are suitable for hospitals,
army camps, factories, etc.
The models RT-15/6 and RT-15/7 are special
models with a mirror for wall-mounting
installation. The connection is the same as
previously. The installation is as follows.
First remove the screws 1A and 1B(Figure
1) which are found at the upper side-wise
and replace them with the plastic holders.
Afterwards install the apparatus on the wall.
Finally place the plastic holders at point
2A and 2B (Figure 1) and fix it on the wall.
925015000_09_010
RT-15/7
270VA
3x36W BL
1A
13.7kgr.
WARRANTY
Olympia Electronics guarantees the quality, condition and operation of the goods. The period of
warranty is specified in the official catalogue of Olympia Electronics and also in the technical leaflet,
which accompanies each product. This warranty ceases to exist if the buyer does not follow the
technical instructions included in official documents given by Olympia Electronics or if the buyer
modifies the goods provided or has any repairs or re-setting done by a third party, unless Olympia
Electronics has fully agreed to them in writing. Products that have been damaged can be returned to
the premises of our company for repair or replacement, as long as the warranty period is valid.
Olympia Electronics reserves the right to repair or to replace the returned goods and to or not charge
the buyer depending on the reason of defection. Olympia Electronics reserves the right to charge or
not the buyer the transportation cost.
HEAD OFFICE
72 km. O.N.R. Thessaloniki-Katerini
nd
P.C. 60300 P.O. Box 06 Εginio Pierias Greece
www.olympia-electronics.com
info@olympia-electronics.gr
Page 2 from 2
Description
1. Hole (for wall-mounted installation).
2. Hole (for wall-mounted installation).
3. Special drawer.
4. Installation point (for normal installation with chain).
5. Fuse holder.
6. Plug.
7. Protection grid.
Figure 1
4
3
2A
7
WARNING!!!
- The device is suitable for internal installation.
- The device must be kept away from children.
- The device must be not installed in areas with
combustible gases or explosive dust.
- The device is not suitable for use in Sheds, cottages,
stables and likewise places.
- If the device's cable is worn or damaged it must be
replaced from OLYMPIA ELECTRONICS SERVICE
department.
5
1B
6
2B
925015000_09_010