packright rightline GEAR StrapRight Strap Set Quick Start Manual

Directions for: StrapRight Strap Set and Car Clip Strap
Set
The correct attachment of this product is critical and
beyond the control of Rightline Gear. The safe use
and long life of this product depends entirely on
your good judgment and following these directions.
The PackRight StrapRight Strap Set
The StrapRight Strap Set (Fig
1) comes standard with all
PackRight Car Top Carriers ex-
cept the Sport Jr. Each set is
comprised of (4) nylon straps,
1" W and over 10' L, with an
800 lb breaking capacity.
The straps are treated with a waterproof coating to prevent
water from wicking through the material. They can be used to
attach the carriers to vehicles with or without a luggage rack.
Using the StrapRight Strap Set WITH a Roof Rack
When using the StrapRight Strap Set for your carrier, nev-
er exceed the roof rack's weight limit. If you are unsure of
the rack's weight limitations, please contact your dealer or
manufacturer.
Attaching the car top carriers with two straps front
to back between the cross bars (Fig 2) or two straps
side to side between the side rails will sufficiently se-
cure the carrier, however, using all four straps pro-
vides the most secure method of attachment (Fig 3).
Fig 2
1-Each StrapRight strap has two
strap pieces connected through a
center buckle. Unthread the short
piece from the buckle and secure
it to your rack by threading its end
through its loop and pulling tight (Fig
4). Go to the opposite side of the
vehicle and secure the long piece
to the rack by the same method.
Fig 1
Fig 3
Fig 4
2-Run both strap pieces through
the d-rings on each side of the
Sport cargo bags (Fig 5) or
through the handles of the Clas-
sic cargo bags and bring them
together on top of the bag.
3-Thread the short strap back through
the center buckle (Fig 6). Make sure
that you have enough length on
each side of the buckle so that the
straps will not pull out under tension.
Using the StrapRight Strap Set WITHOUT a Roof Rack
Through The Vehicle
Run the StrapRight
Straps through the open
doors of the vehicle and
around the carrier to
secure the load (Fig 7).
1-Each strap has two strap piec-
es connected through a center
buckle. First, unthread the short
strap piece from the center buckle
and connect its loop end with the
loop end of the long piece (Fig
8) to make one long strap again.
2-Run the strap through the open vehicle and through
the d-rings on each side of the Sport cargo bags or
through the handles on the sides of the Classic cargo
bag, bringing the two ends together over the top of the
carrier. Then rethread the short strap back through the
center buckle (Fig 6 above) and tighten appropriately.
NOTE: With some larger vehicles, one strap may not be
long enough. If that is the case, you can connect two straps
together using a similar procedure as described above:
1-Leave one strap as originally provided and separate
the two pieces of the second strap by unthreading the
short strap piece from the center buckle.
2-Connect the loop end of each of those piec-
es to each loop end of the first strap (Fig 8 above).
3-You will end up with one double long strap that can be
run through the vehicle, through the d-rings or handles on
the sides of the cargo bag, and over the top of the carrier.
4-Rethread the short strap back through the center buckle
(Fig 6 above) and tighten.
Fig 5
Fig 6
Fig 7
Fig 8